CHI Plumbing Systems Inspection Flashcards
6 cards from real CHI practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 CHI Plumbing Systems Inspection flashcards as text
When inspecting a water heater, what is the minimum required clearance between the relief valve discharge pipe and the floor drain?
Answer: 6 inches
The TPR valve discharge pipe must terminate within 6 inches of the floor to safely direct scalding water away without creating a hazard.
Which pipe material is most commonly identified by its blue or black color and is approved for cold water supply lines in residential construction?
Answer: PEX
PEX (cross-linked polyethylene) is commonly color-coded blue for cold water and red for hot water in residential plumbing systems.
A home inspector observes that a p-trap under a bathroom sink is installed without a vent pipe. What issue should be documented?
Answer: Sewer gas infiltration risk
Without proper venting, negative pressure can siphon water out of the p-trap, allowing sewer gases to enter the living space.
What is the maximum water pressure recommended at the point of entry to a residential plumbing system according to most US plumbing codes?
Answer: 80 PSI
Most US plumbing codes recommend a maximum static water pressure of 80 PSI at the service entry to prevent damage to fixtures and appliances.
During a home inspection, the inspector notices galvanized steel supply pipes with visible orange staining at joints. What is the most likely concern?
Answer: Internal corrosion reducing water flow
Orange staining at joints of galvanized pipes indicates internal rust and corrosion, which progressively reduces pipe diameter and water flow.
Which condition would a home inspector classify as a safety deficiency when evaluating a gas water heater installation?
Answer: Combustion air drawn from inside the conditioned space
Gas water heaters require adequate combustion air; drawing it from a small enclosed space can cause incomplete combustion and carbon monoxide production.
Written and edited by Nathan Beja, founder of Practice Test Geeks, with AI assistance. Exam facts are checked against the official sources linked below. Editorial policy
Sources & references
Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy
- nationalhomeinspectorexam.org — Test delivery, fees, exam format, passing score, retake policy, test dates, time limit, exam information · verified Nov 2026
- test-takers.psiexams.com — Retake fee, score release, score validity · verified Nov 2026