Practice Test GeeksCFESA - Commercial Food Equipment Service Association Practice Test
← All CFESA Flashcard Decks

Diagnostic Troubleshooting Flashcards

7 cards from real CFESA practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Diagnostic Troubleshooting flashcards as text

  1. A commercial convection oven heats unevenly, with the back hotter than the front. Which component is most likely failing?

    Answer: Convection fan motor

    A failing convection fan motor reduces or disrupts airflow, causing uneven heat distribution within the oven cavity.

  2. A walk-in cooler compressor short-cycles every 2-3 minutes. After ruling out refrigerant issues, what should the technician check next?

    Answer: High-pressure cutout switch

    A high-pressure cutout switch tripping repeatedly causes short-cycling and often indicates condenser fouling or airflow restriction.

  3. A commercial dishwasher's wash arms are not rotating. The pump motor runs normally. What is the most likely cause?

    Answer: Clogged or blocked wash arm ports

    Clogged wash arm ports restrict water flow and prevent the hydraulic pressure needed to spin the wash arms.

  4. A gas fryer burner lights but extinguishes within 30 seconds. The technician confirms adequate gas pressure. What is the most probable fault?

    Answer: Faulty thermocouple or flame sensor

    A weak or failed thermocouple/flame sensor cannot generate sufficient millivoltage to hold the gas valve open, causing burner dropout.

  5. During startup, a steam kettle pressure gauge reads normal but the kettle is not heating. Which diagnostic step should be performed first?

    Answer: Confirm the steam solenoid valve is opening

    If pressure is present but heat is absent, the steam solenoid valve may be stuck closed and preventing steam from entering the jacket.

  6. A refrigerated prep table shows ice buildup on the evaporator coil between scheduled defrosts. What condition does this most likely indicate?

    Answer: Excessive moisture infiltration from a failing door seal

    A failing door gasket allows warm, moist ambient air to enter, which freezes on the evaporator coil faster than scheduled defrost cycles can clear it.

  7. A technician measures 24 VAC at the control board output but a gas valve does not open. What is the correct next diagnostic action?

    Answer: Check resistance across the gas valve coil terminals

    Measuring coil resistance confirms whether the gas valve solenoid is open-circuited, shorted, or within specification before condemning the valve.

How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy

Sources & references

Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy

  1. cfesa.com — Test delivery, eligibility, registration, renewal, score validity, exam information · verified Oct 2026