Practice Test Geeks(CFB) Certified Field Builder Practice Test
← All CFB Flashcard Decks

Safety Regulations & Compliance Flashcards

7 cards from real CFB practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Safety Regulations & Compliance flashcards as text

  1. What is the purpose of a Tailgate Safety Meeting (toolbox talk) held before daily construction activities begin?

    Answer: To communicate site-specific hazards and safe work procedures to the crew

    Tailgate meetings ensure all workers are briefed on daily hazards, safe procedures, and any changed site conditions before work starts.

  2. Under OSHA standards, what action must be taken before a worker enters an excavation greater than 4 feet deep to test for hazardous atmospheres?

    Answer: Test the air with a calibrated atmospheric monitor

    OSHA 1926.651(g) requires atmospheric testing in excavations deeper than 4 feet where a hazardous atmosphere could reasonably exist.

  3. Which of the following activities on a construction site requires a Hot Work Permit?

    Answer: Using an oxy-acetylene torch near flammable materials

    Hot work permits are required for operations producing open flames, sparks, or heat near combustible materials, such as torch cutting or welding.

  4. A field builder is setting up scaffolding that will exceed 10 feet in height. Who must design and supervise the erection of this scaffold according to OSHA 1926 Subpart L?

    Answer: A qualified person or registered engineer where required

    OSHA Subpart L requires a qualified person to design scaffolding, and a registered engineer is required for complex or suspended scaffold systems.

  5. Which right is guaranteed to construction workers under OSHA's worker rights provisions?

    Answer: The right to refuse work that poses imminent danger without fear of retaliation

    Section 11(c) of the OSH Act protects workers who refuse work presenting imminent danger from employer retaliation.

  6. What does a 'competent person' designation mean under OSHA construction standards?

    Answer: Someone capable of identifying hazards and authorized to take corrective action

    OSHA defines a competent person as one who can identify existing and predictable hazards and has the authority to eliminate them.

  7. Under NFPA 70E and OSHA 1926.416, what must be verified before a worker performs maintenance on electrical panels in a construction setting?

    Answer: That the circuit is de-energized, locked out, and tested for absence of voltage

    Before electrical maintenance, LOTO procedures must de-energize the circuit, and a voltage tester must confirm zero energy state.