CET Safety and Health Protocols 3

Question 1

Which ventilation requirement is most critical when using carbon monoxide (CO) as a secondary euthanasia method?

Accepted Answer

Maintaining CO concentration below OSHA's permissible exposure limit of 50 ppm in the work area

Answer

OSHA's PEL for CO is 50 ppm as an 8-hour TWA; ventilation systems must prevent worker exposure from exceeding this limit.

Question 2

The Safety Data Sheet (SDS) for sodium pentobarbital must be accessible to euthanasia staff:

Accepted Answer

At all times during each work shift

Answer

OSHA's HazCom Standard requires that SDS documents be readily accessible to employees during their work shifts.

Question 3

Compassion fatigue in euthanasia technicians is best addressed through which organizational safety measure?

Accepted Answer

Providing regular access to mental health resources, peer support, and rotation of duties

Answer

Structured mental health support, peer programs, and duty rotation are evidence-based strategies to mitigate compassion fatigue in animal care workers.

Question 4

Which of the following represents the correct order for donning (putting on) PPE before a euthanasia procedure?

Accepted Answer

Gown → mask/respirator → eye protection → gloves

Answer

The correct donning sequence is gown first, then respiratory protection, then eye/face protection, and finally gloves to maintain barrier integrity.

Question 5

A euthanasia technician notices a crack in a CO chamber seal. The correct response is to:

Accepted Answer

Immediately take the chamber out of service and tag it until repaired

Answer

Any breach in a CO chamber compromises worker safety and must result in immediate removal from service until properly repaired.

(CET) Certified Euthanasia Technician Practice Test

(CET) Certified Euthanasia Technician Practice Test

CET Safety and Health Protocols 3