Certified Welder Welding Processes and Equipment Questions and Answers 1

Question 1

A welding machine is rated at 300 amps with a 60% duty cycle. How long can this machine weld continuously at 300 amps before it requires a cooling period, based on a standard 10-minute cycle?

Accepted Answer

6 minutes

Answer

Duty cycle represents the percentage of time a machine can operate within a 10-minute period without overheating. A 60% duty cycle means the machine can weld for 60% of that 10-minute window, which is 6 minutes, and then must cool for the remaining 4 minutes.

Question 2

When performing Gas Tungsten Arc Welding (GTAW) on aluminum, which type of current and tungsten electrode tip preparation is most commonly recommended?

Accepted Answer

AC with a balled tip

Answer

Alternating Current (AC) is preferred for welding aluminum because its cleaning action helps remove the resilient aluminum oxide layer. A balled tip, which forms naturally on pure or zirconiated tungsten electrodes under AC conditions, provides a stable arc for this application.

Question 3

A welder is setting up for Gas Metal Arc Welding (GMAW) on carbon steel using the short-circuit transfer method. Which of the following shielding gases would be most appropriate for this application?

Accepted Answer

75% Argon / 25% Carbon Dioxide

Answer

A mixture of 75% Argon and 25% Carbon Dioxide is the most common and effective shielding gas for short-circuit GMAW on carbon steel. The argon provides arc stability while the CO2 provides good bead penetration and a wider weld profile, a combination ideal for this process.

Question 4

Which of the following welding processes uses a non-consumable electrode?

Accepted Answer

Gas Tungsten Arc Welding (GTAW)

Answer

Gas Tungsten Arc Welding (GTAW), also known as TIG welding, is unique among these options because it uses a non-consumable tungsten electrode to create the arc. The filler metal, if required, is added separately to the weld pool. SMAW, FCAW, and GMAW all use consumable electrodes that melt to become part of the weld.

Question 5

In Shielded Metal Arc Welding (SMAW), selecting DCEN (Direct Current Electrode Negative) polarity generally results in:

Accepted Answer

Shallower penetration and a higher deposition rate.

Answer

With DCEN, or straight polarity, electrons flow from the electrode to the workpiece. This concentrates more heat (about two-thirds) on the workpiece, leading to deeper penetration. However, because the electrode stays cooler, the deposition rate is typically faster compared to DCEP. Some sources indicate shallower penetration. Based on the most consistent information, DCEN concentrates heat on the workpiece, which leads to deeper penetration, but other sources state DCEN is used for less penetration on thin materials. For the purpose of this question, we will align with the principle that more heat on the workpiece increases penetration and a cooler electrode increases deposition rate. Let's re-evaluate. Multiple sources indicate DCEN results in *less* penetration for SMAW. In DCEN, more heat is on the workpiece, but for SMAW, DCEP provides a digging arc that results in deeper penetration. DCEN provides a higher deposition rate because the electrode melts faster. So, DCEN results in shallower penetration and a faster deposition rate.

Certified Welder Practice Test

Certified Welder Practice Test

Certified Welder Welding Processes and Equipment Questions and Answers 1