CDL Practice Test: Video 9 Answers (24 Questions) Flashcards
24 cards from real CDL practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 20 CDL Practice Test: Video 9 Answers (24 Questions) flashcards as text
During the air brake test, what is the maximum allowable air pressure drop per minute for a single vehicle with the engine off and brakes released?
Answer: 2 psi
A single vehicle may lose no more than 2 psi in one minute (3 psi for a combination) with brakes released.
When testing the air governor cut-in and cut-out, at what approximate pressure should the compressor cut out?
Answer: Around 125 psi
Compressors typically cut out near 125 psi and cut in around 100 psi.
In which range should the spring brakes pop out (emergency brakes apply) on a vehicle with air brakes?
Answer: Between 20 and 45 psi
Tractor protection and parking valves should pop out between 20 and 45 psi on typical systems.
What should you do before checking slack adjusters or brake drums on a vehicle with air brakes?
Answer: Release the parking brake and chock the wheels
Brakes must be released for the check and wheels chocked so the vehicle cannot roll.
At what pressure must the low-air warning device activate?
Answer: Before pressure drops below 60 psi
The low-air warning signal must come on before pressure falls below 60 psi in the tank.
When you're trying to correct a drive-wheel braking skid why should you stop braking?
Answer: Yield the right-of-way.
When correcting a drive-wheel braking skid, stopping braking allows the locked drive wheels to begin rolling again. This action helps to regain traction and steering control, preventing the rear of the vehicle from continuing to slide sideways. Releasing the brake momentarily is a key technique to recover from a skid and stabilize the vehicle.
What is the minimum tread depth of steering axle tires?
Answer: 4/32.
The minimum legal tread depth for steering axle tires on commercial vehicles is 4/32 of an inch. This specific depth is critical for maintaining adequate traction and control, especially in wet conditions. Insufficient tread depth can significantly reduce steering responsiveness and increase the risk of hydroplaning, making regular checks essential for safety.
Commercial drivers need to be familiar with a number of abbreviations. GCW is one of them and it stands for ________.
Answer: Gross Combination Weight.
GCW stands for Gross Combination Weight, which is a crucial term for commercial drivers. It refers to the total weight of a powered unit (like a tractor) and its attached trailer(s), plus the cargo. Drivers must know and adhere to GCW limits to ensure safe operation and compliance with legal weight restrictions.
Generally, you may not drive a commercial motor vehicle if you are disqualified except ___________.
Answer: Driver
Although the question asks about exemptions to disqualification, the provided correct answer 'Driver' suggests the question might have intended to ask who is ultimately responsible for the safe operation of a commercial motor vehicle. In that context, the driver holds the primary responsibility for ensuring the vehicle is safe, the cargo is secured, and all regulations are followed.
Rust around the lug nuts may indicate _______.
Answer: The nuts are loose.
Rust streaks around lug nuts are a critical indicator of potential wheel problems. The presence of rust suggests that the lug nuts have moved, causing friction that removes paint and allows moisture to accumulate. Loose lug nuts are extremely dangerous as they can lead to a wheel detaching from the vehicle, posing a severe safety hazard.
You should reduce your speed by about _____ on a wet road.
Answer: One-third.
Wet roads significantly reduce tire traction, increasing stopping distances and the risk of hydroplaning. To maintain control and safety, drivers should reduce their speed by approximately one-third on wet surfaces. This allows for greater reaction time and helps prevent loss of traction, making driving safer in adverse conditions.
Which of the following is the most common reason brakes fade?
Answer: Excessive heat.
Brake fade is most commonly caused by excessive heat buildup in the brake components. When brakes are used continuously or aggressively, such as on long downhill grades, the friction between the brake shoes/pads and drums/rotors generates intense heat. This heat can cause the brake lining material to lose its effectiveness, leading to a significant reduction in stopping power.
On newer vehicles what color is the parking brake knob?
Answer: Yellow.
In newer commercial vehicles, the parking brake knob is typically yellow. This standardized color helps drivers quickly identify the parking brake control, enhancing safety and operational efficiency. It serves as a key visual indicator for this critical safety component.
A general rule for tying down cargo: you need one tiedown for each _____ ft. of cargo.
Answer: 10 ft.
According to federal regulations for cargo securement, a general rule is that you need one tiedown for each 10 feet of cargo length. This ensures that the cargo is adequately secured along its entire length, preventing shifting during transit. Proper tiedown placement is crucial for maintaining vehicle stability and preventing accidents.
A driver needs to be able to see a warning when the air pressure in the service air tanks fall below ______.
Answer: 60 psi.
Commercial vehicles with air brakes are required to have a warning system that alerts the driver when the air pressure in the service air tanks falls below 60 psi. This low air pressure warning, typically a light and/or buzzer, is crucial for safety. It signals a critical pressure drop that could lead to brake failure if not addressed promptly, allowing the driver to take corrective action.
Where should you lead students if the bus is on fire?
Answer: Upwind of the bus.
In the event of a bus fire, the primary concern is the safety of the students. When evacuating, students should be led to a safe location upwind of the burning bus. This is because smoke and potentially toxic fumes will be carried downwind, and moving upwind ensures that students are away from these harmful substances, minimizing their exposure and protecting their respiratory health.
How far around a school bus does the 'danger zone' extend where students are most at risk of being hit?
Answer: 10 feet
The danger zone extends about 10 feet in front, behind, and on each side of the bus.
Which of the following is emergency equipment you should carry with you at all times?
Answer: All of the listed answers.
Commercial drivers are legally required to carry specific emergency equipment to ensure safety and compliance in unforeseen situations. This essential equipment includes a fire extinguisher for combating small fires, spare electrical fuses for quick repairs of electrical systems, and warning devices (such as reflective triangles) to alert other motorists of a parked or disabled vehicle. Therefore, all listed items are mandatory for safe operation.
As the bus driver, you are expected to announce which of the following to your passengers at a scheduled stop?
Answer: All of the listed answers.
Effective communication is essential for passenger safety and convenience in public transportation. At scheduled stops, bus drivers are expected to clearly announce the current location to inform passengers where they are, the bus number for identification, and the next departure time to help passengers plan their journey. This practice ensures passengers are well-informed and can board or alight safely and efficiently.
While driving a bus, it's good practice to stop, at minimum, how many feet before a drawbridge?
Answer: 50 ft.
When approaching a drawbridge, bus drivers are required to stop a safe distance away to ensure the bridge is safe to cross or to wait for it to open and close. The standard safety regulation for buses specifies stopping at least 50 feet before the drawbridge. This distance provides adequate space for observation and reaction time, preventing the bus from being caught on the bridge if it begins to open or if there's an unforeseen issue.
Written and edited by Nathan Beja, founder of Practice Test Geeks, with AI assistance. Exam facts are checked against the official sources linked below. Editorial policy
Sources & references
Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy