← All CDCP Flashcard Decks

Network Infrastructure and Connectivity Flashcards

6 cards from real CDCP practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 6 Network Infrastructure and Connectivity flashcards as text
  1. Which network topology is most commonly used within a data center to provide redundancy and high availability?

    Answer: Fat-tree (spine-leaf) topology

    The fat-tree (spine-leaf) topology is preferred in data centers because it provides multiple equal-cost paths, eliminating single points of failure and enabling non-blocking bandwidth.

  2. What is the primary purpose of a Top-of-Rack (ToR) switch in a data center?

    Answer: To aggregate traffic from servers within a single rack before uplink to core switches

    A ToR switch aggregates server connections within a rack and provides uplinks to distribution or spine-layer switches, reducing cable runs across the data floor.

  3. In data center networking, what does 'oversubscription ratio' refer to?

    Answer: The ratio of total downstream bandwidth to available upstream bandwidth

    Oversubscription ratio describes how much downstream port bandwidth is shared across limited upstream bandwidth, e.g., a 4:1 ratio means four times more downstream capacity than upstream.

  4. Which protocol is used to prevent Layer 2 switching loops in a data center network?

    Answer: Spanning Tree Protocol (STP)

    Spanning Tree Protocol (STP) and its variants (RSTP, MSTP) block redundant paths to prevent Layer 2 loops while maintaining failover capability.

  5. What is the recommended minimum fiber type for supporting 40GbE and 100GbE connections in modern data centers?

    Answer: OM3 or OM4 multimode fiber

    OM3 and OM4 multimode fibers support 40GbE and 100GbE at sufficient distances (100m for OM3, 150m for OM4) required within data center environments.

  6. Which feature allows a data center network to carry multiple VLANs over a single physical link between switches?

    Answer: VLAN trunking (IEEE 802.1Q)

    IEEE 802.1Q VLAN trunking tags Ethernet frames with a VLAN ID, allowing a single physical link to carry traffic for multiple VLANs simultaneously.

Written and edited by , founder of Practice Test Geeks, with AI assistance. Exam facts are checked against the official sources linked below. Editorial policy

Sources & references

Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy

  1. epi-ap.com — Eligibility, exam format, passing score, score validity, retake policy, renewal, test delivery, exam information · verified Oct 2026
  2. exin.com — Time limit · verified Oct 2026