CCS Safety Regulations & Compliance 3

Question 1

What is the maximum permissible noise exposure level for an 8-hour workday under OSHA's construction noise standard?

Accepted Answer

90 dBA

Answer

OSHA 29 CFR 1926.52 sets the permissible exposure limit (PEL) at 90 dBA for an 8-hour workday in construction.

Question 2

A CCS specifier must reference the correct standard for lead paint abatement in renovation of pre-1978 construction. Which EPA rule applies?

Accepted Answer

EPA RRP Rule (40 CFR Part 745)

Answer

The EPA's Renovation, Repair and Painting (RRP) Rule at 40 CFR Part 745 governs lead-safe work practices during renovation of pre-1978 buildings.

Question 3

Which specification section division typically contains requirements for a site-specific safety plan and emergency action procedures?

Accepted Answer

Division 01 – General Requirements

Answer

Division 01 General Requirements contains administrative and procedural requirements including safety plans and emergency action procedures.

Question 4

OSHA's Process Safety Management (PSM) standard applies to construction activities involving highly hazardous chemicals above threshold quantities. Which OSHA standard number covers PSM?

Accepted Answer

29 CFR 1910.119

Answer

OSHA's PSM standard is codified at 29 CFR 1910.119 and applies when construction involves highly hazardous chemicals above specified threshold quantities.

Question 5

What minimum angle from horizontal must an extension ladder be positioned at for safe use per OSHA construction standards?

Accepted Answer

75.5 degrees (4:1 pitch ratio)

Answer

OSHA requires portable ladders to be set up at a pitch of 4 horizontal to 1 vertical (approximately 75.5°), per 29 CFR 1926.1053.

(CCS) Certified Construction Specifier Practice Test

(CCS) Certified Construction Specifier Practice Test

CCS Safety Regulations & Compliance 3