Practice Test Geeks(CCS) Certified Construction Specifier Practice Test
← All CCS Flashcard Decks

Safety Regulations & Compliance Flashcards

7 cards from real CCS practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Safety Regulations & Compliance flashcards as text

  1. What does the acronym 'SDS' stand for in the context of OSHA's Hazard Communication Standard, and how many sections does it contain?

    Answer: Safety Data Sheet; 16 sections

    An SDS (Safety Data Sheet) contains exactly 16 sections following the GHS format adopted in OSHA's HazCom 2012 update.

  2. When must a contractor submit an Asbestos Notification to the appropriate federal or state agency before beginning renovation or demolition work?

    Answer: At least 10 working days before commencing work involving regulated asbestos-containing material (RACM)

    EPA NESHAP (40 CFR Part 61 Subpart M) requires at least 10 working days advance notification before renovation or demolition disturbing RACM.

  3. Which type of protective system for trenches and excavations involves sloping the walls to reduce the angle of the trench face?

    Answer: Sloping and benching

    Sloping and benching involves cutting back trench walls at a stable angle to prevent cave-in, as defined in OSHA 29 CFR 1926 Subpart P Appendix B.

  4. A construction specification references ANSI/ISEA Z87.1. What type of personal protective equipment does this standard govern?

    Answer: Eye and face protection

    ANSI/ISEA Z87.1 is the American National Standard for Occupational and Educational Personal Eye and Face Protection Devices.

  5. Under OSHA's electrical safety requirements for construction, what is the minimum clearance required when working near unguarded energized overhead lines rated at 50kV or less?

    Answer: 10 feet

    OSHA 29 CFR 1926.1408 requires a minimum 10-foot clearance from unguarded energized overhead lines rated at 50kV or below.

  6. The CSI specifier is incorporating fire watch requirements into a hot work specification. Which NFPA document is the primary reference for fire watch procedures during construction?

    Answer: NFPA 51B, Standard for Fire Prevention During Welding, Cutting, and Other Hot Work

    NFPA 51B specifically addresses fire prevention during welding, cutting, and other hot work operations including fire watch requirements.

  7. What is the required minimum illumination level (in foot-candles) for general construction areas, ramps, runways, corridors, offices, shops, and storage areas according to OSHA?

    Answer: 5 foot-candles

    OSHA 29 CFR 1926.56(a) Table D-3 requires a minimum of 5 foot-candles for general construction areas, corridors, storage areas, and similar locations.