Practice Test Geeks(CCS) Certified Construction Specifier Practice Test
← All CCS Flashcard Decks

Safety Regulations & Compliance Flashcards

7 cards from real CCS practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Safety Regulations & Compliance flashcards as text

  1. Which CSI MasterFormat section number is typically used to specify Health, Safety, and Emergency Response procedures?

    Answer: 01 35 29

    MasterFormat Section 01 35 29 is designated for Health, Safety, and Emergency Response within the Division 01 General Requirements.

  2. A specifier is writing requirements for personal protective equipment (PPE). Which OSHA standard mandates that employers provide PPE at no cost to employees?

    Answer: Both A and B

    Both 29 CFR 1926.95 (construction) and 29 CFR 1910.132 (general industry) require employers to provide required PPE at no cost to employees.

  3. The Americans with Disabilities Act (ADA) requires accessible routes on construction sites when the site is open to the public. Which ADA Standards section addresses temporary facilities?

    Answer: ADA Standards Section 206.2.1

    ADA Standards Section 206.2.1 requires accessible routes to temporary facilities when the site is open to the public during construction.

  4. When specifying crane operations, which OSHA standard governs cranes and derricks in construction?

    Answer: 29 CFR 1926 Subpart CC

    OSHA 29 CFR 1926 Subpart CC (Cranes and Derricks in Construction) governs crane operations specifically in the construction industry.

  5. Under OSHA's silica standard for construction (29 CFR 1926.1153), what is the permissible exposure limit (PEL) for respirable crystalline silica?

    Answer: 50 μg/m³ as an 8-hour TWA

    OSHA's silica standard sets a PEL of 50 μg/m³ as an 8-hour TWA for respirable crystalline silica in construction.

  6. Which standard should a CCS specifier reference when specifying safety requirements for temporary heating equipment used during winter construction?

    Answer: NFPA 241, Standard for Safeguarding Construction, Alteration, and Demolition Operations

    NFPA 241 specifically addresses fire and life safety during construction, alteration, and demolition operations including temporary heating.

  7. A specification requires contractors to maintain a written Injury and Illness Prevention Program (IIPP). This requirement primarily derives from which regulatory framework?

    Answer: Cal/OSHA Title 8, CCR Section 3203 (California) or equivalent State Plan requirements

    IIPPs are mandated by California's Cal/OSHA (Title 8 CCR 3203) and similar State Plan requirements; federal OSHA does not have a universal IIPP mandate.