Car Wraps Ultimate 5

Question 1

A customer complains of bubbles appearing days after installation. Small bubbles that were not pierced should be handled how?

Accepted Answer

Warm the area and press air toward the nearest edge or pierce with a fine air-release pin

Answer

Cut a large X over each bubble

Answer

Ignore them; they always disappear in rain

Answer

Remove the entire wrap immediately

Question 2

Which US regulatory consideration applies to wrapping a vehicle's windows with perforated window film?

Accepted Answer

Front driver and passenger windows generally cannot be covered; laws vary by state

Answer

All windows may always be fully covered

Answer

Only the windshield may be wrapped

Answer

Window film requires federal DOT registration

Question 3

What is the purpose of the wrap technique called 'bridging' followed by working the film into a recess?

Accepted Answer

Laying film flat across a recess first, then using heat and pressure to seat it without overstretching

Answer

Joining two rolls of vinyl with tape

Answer

Wrapping over rust to hide it

Answer

Installing film underwater

Question 4

Why should a freshly wrapped vehicle avoid washing for the first 24 to 48 hours?

Accepted Answer

The pressure-sensitive adhesive needs time to fully bond to the surface

Answer

The vinyl color is still wet

Answer

Water dissolves new vinyl

Answer

The clear coat underneath is still curing

Question 5

A shop is choosing film for a two-year promotional fleet campaign on flat trailer sides. Which film is the most cost-effective appropriate choice?

Accepted Answer

Calendered vinyl, since flat surfaces do not require cast film conformability

Answer

Premium cast vinyl with maximum stretch

Answer

Paint protection film

Answer

Chrome cast film

Question 6

What does 'wet-out' refer to in vinyl wrap terminology?

Accepted Answer

The adhesive flowing and fully contacting the substrate for maximum bond

Answer

Spraying the panel with water before install

Answer

Vinyl becoming saturated in rain

Answer

The gloss level of the finished wrap

Question 7

An installer must wrap over a body line where two vinyl panels meet. What overlap practice is standard?

Accepted Answer

Overlap seams about a quarter to half inch, positioned away from direct visual lines when possible

Answer

Butt the edges with a visible gap

Answer

Overlap at least four inches on every seam

Answer

Glue the seam with superglue