CAL Key Generation and Duplication 2

Question 1

When generating a key by code for a vehicle, which measurement system is most commonly used in modern automotive key cutting equipment?

Accepted Answer

Standard depth-and-space values from the manufacturer's key code

Answer

Modern automotive key cutting equipment relies on manufacturer-supplied depth-and-space values derived from the key code to ensure precision.

Question 2

A customer presents a Ford vehicle with a lost key. The locksmith locates the key code on the door lock cylinder. This type of code retrieval is known as:

Accepted Answer

Direct code reading

Answer

Direct code reading involves physically reading the code stamped or engraved on a lock component of the vehicle.

Question 3

Which of the following best describes 'key cloning' in automotive locksmithing?

Accepted Answer

Copying the transponder signal from one key to a new blank

Answer

Key cloning specifically refers to copying the transponder chip's data from an existing working key onto a compatible blank chip.

Question 4

When using a code cutter to generate a key by code, the locksmith must ensure the key blank is properly:

Accepted Answer

Aligned to the zero-stop or datum position

Answer

Proper alignment to the zero-stop or datum position ensures all depth cuts are placed accurately relative to the key blank's reference point.

Question 5

A 'secondary code' on an automotive key typically refers to:

Accepted Answer

A code that translates to bitting specifications via a code book

Answer

A secondary code must be looked up in a code book or software to convert it into actual bitting depth-and-space values for cutting.

(CAL) Certified Automotive Locksmith Practice Test

(CAL) Certified Automotive Locksmith Practice Test

CAL Key Generation and Duplication 2