BAT Breath Alcohol Technician Safety & Regulatory Compliance 3

Question 1

Which section of 49 CFR Part 40 specifically governs the qualifications and responsibilities of Breath Alcohol Technicians?

Accepted Answer

Subpart F

Answer

Subpart F of 49 CFR Part 40 (Sections 40.211–40.229) addresses the procedures and responsibilities of BATs.

Question 2

A BAT must be trained and proficient in using a specific EBT model. If they switch to a new device model, what is required?

Accepted Answer

Manufacturer-provided training on the new model is required

Answer

BATs must receive training from the manufacturer or their representative on any new EBT model before using it for DOT testing.

Question 3

What is the purpose of the external calibration check performed on an EBT?

Accepted Answer

To confirm the device's accuracy against a known alcohol standard

Answer

External calibration checks verify that an EBT reads correctly by comparing its output to a known wet or dry gas alcohol reference standard.

Question 4

Under DOT rules, who is responsible for ensuring the BAT is properly trained and qualified?

Accepted Answer

The employer or their designated service agent (C/TPA)

Answer

Employers and their Consortium/Third Party Administrators (C/TPAs) are responsible for ensuring BATs are qualified and maintain proper credentials.

Question 5

When conducting a DOT breath alcohol test, the BAT must print and give the employee which copy of the alcohol testing form?

Accepted Answer

Copy 3 (yellow)

Answer

Copy 3 (yellow) of the Federal Breath Alcohol Testing Form is the employee's copy to retain.

(BAT) Breath Alcohol Technician Certified Practice Test