BAT Breath Alcohol Technician Safety & Regulatory Compliance 3 — Questions and Answers
Question 1: Which section of 49 CFR Part 40 specifically governs the qualifications and responsibilities of Breath Alcohol Technicians?
- Subpart E
- Subpart F (Correct answer)
- Subpart G
- Subpart H
Correct answer: Subpart F
Subpart F of 49 CFR Part 40 (Sections 40.211–40.229) addresses the procedures and responsibilities of BATs.
Question 2: A BAT must be trained and proficient in using a specific EBT model. If they switch to a new device model, what is required?
- No additional training is needed
- Manufacturer-provided training on the new model is required (Correct answer)
- Only a refresher course every 5 years is required
- DOT must re-certify the BAT for each device
Correct answer: Manufacturer-provided training on the new model is required
BATs must receive training from the manufacturer or their representative on any new EBT model before using it for DOT testing.
Question 3: What is the purpose of the external calibration check performed on an EBT?
- To verify the device prints results accurately
- To confirm the device's accuracy against a known alcohol standard (Correct answer)
- To reset the device's memory after each use
- To check battery life before a testing session
Correct answer: To confirm the device's accuracy against a known alcohol standard
External calibration checks verify that an EBT reads correctly by comparing its output to a known wet or dry gas alcohol reference standard.
Question 4: Under DOT rules, who is responsible for ensuring the BAT is properly trained and qualified?
- The employee being tested
- The BAT themselves
- The employer or their designated service agent (C/TPA) (Correct answer)
- The EBT manufacturer
Correct answer: The employer or their designated service agent (C/TPA)
Employers and their Consortium/Third Party Administrators (C/TPAs) are responsible for ensuring BATs are qualified and maintain proper credentials.
Question 5: When conducting a DOT breath alcohol test, the BAT must print and give the employee which copy of the alcohol testing form?
- Copy 1 (white)
- Copy 2 (green)
- Copy 3 (yellow) (Correct answer)
- A digital copy via email
Correct answer: Copy 3 (yellow)
Copy 3 (yellow) of the Federal Breath Alcohol Testing Form is the employee's copy to retain.
Question 6: A screening test result of 0.00 g/210L means the BAT should:
- Conduct an immediate confirmation test
- Wait 15 minutes and retest
- Report the result as negative and end testing (Correct answer)
- Contact the MRO for guidance
Correct answer: Report the result as negative and end testing
A screening result of 0.00 g/210L is a negative result, and no further alcohol testing is required.
Question 7: Which document must an EBT manufacturer provide to demonstrate the device meets DOT standards before it can be used in federal workplace testing?
- An OSHA safety certification
- Listing on the NHTSA Conforming Products List (CPL) (Correct answer)
- A DEA Schedule II exemption letter
- An EPA environmental impact statement
Correct answer: Listing on the NHTSA Conforming Products List (CPL)
Only EBT models listed on the NHTSA Conforming Products List are approved for use in DOT mandated breath alcohol testing.
BAT Breath Alcohol Technician Safety & Regulatory Compliance 3
Which section of 49 CFR Part 40 specifically governs the qualifications and responsibilities of Breath Alcohol Technicians?