BAI Risk Management & Mitigation 3 — Questions and Answers
Question 1: Which scenario represents a 'near-miss' that must be documented in archery range management?
- An archer scores lower than expected on a target
- An arrow passes through a target butt and lands in the safety zone beyond (Correct answer)
- An archer forgets their arm guard at home
- A bow grip becomes sweaty during a hot session
Correct answer: An arrow passes through a target butt and lands in the safety zone beyond
An arrow passing through a target butt and entering the safety zone is a near-miss event that reveals a safety system failure requiring documentation and corrective action.
Question 2: What is the recommended action if a target butt shows significant wear and arrow pass-through becomes possible?
- Continue use until an arrow actually passes through, then replace
- Remove it from service immediately and replace or repair before further use (Correct answer)
- Reduce the draw weight limit for archers using that target
- Place an additional paper target face over the worn area
Correct answer: Remove it from service immediately and replace or repair before further use
A butt that risks arrow pass-through must be taken out of service immediately to prevent arrows from reaching the area behind the target.
Question 3: A certified BAI instructor should intervene IMMEDIATELY if they observe which behavior on a practice range?
- An archer adjusting their stance between shots
- An archer walking toward the targets while others are still shooting (Correct answer)
- An archer using a finger tab instead of a glove
- An archer using a recurve bow instead of a compound bow
Correct answer: An archer walking toward the targets while others are still shooting
Walking downrange while others are shooting creates an immediate lethal hazard and requires instant instructor intervention.
Question 4: What does the term 'overshoot area' refer to in range design?
- An area where archers with high draw weights must shoot
- The safety zone beyond the targets that arrows must not reach (Correct answer)
- A designated space for archers shooting at longer distances
- A marked zone where missed shots are collected
Correct answer: The safety zone beyond the targets that arrows must not reach
The overshoot area is the buffer zone behind the targets designed to stop or contain any arrows that pass through or over the target butts.
Question 5: An archer reports that their bow makes a loud 'thwack' when dry-fired by accident. What is the instructor's primary concern?
- Noise disturbance to other archers on the range
- Potential structural damage to the bow that could cause limb failure (Correct answer)
- Loss of draw weight calibration requiring re-tuning
- Possible string stretching that will affect arrow speed
Correct answer: Potential structural damage to the bow that could cause limb failure
Dry-firing can cause catastrophic limb failure, so the bow must be thoroughly inspected before it is used again to prevent injury.
Question 6: Which type of arrow damage is MOST dangerous and should result in immediate removal from use?
- A scratched shaft with no structural compromise
- A cracked or splintered shaft that could shatter on release (Correct answer)
- Minor fletching wear reducing arrow stabilization
- A slightly bent aluminum shaft causing decreased accuracy
Correct answer: A cracked or splintered shaft that could shatter on release
A cracked or splintered shaft can shatter during release, driving sharp fragments into the archer's hand or face.
Question 7: Why is it important to establish a specific 'all clear' signal before archers retrieve arrows?
- To allow the scorer to record results before arrows are pulled
- To ensure all shooting has stopped and the range is safe before anyone approaches the targets (Correct answer)
- To give bow technicians time to inspect equipment between ends
- To allow the range officer to reset the timer for the next end
Correct answer: To ensure all shooting has stopped and the range is safe before anyone approaches the targets
A definitive all-clear signal confirms that all archers have stopped shooting and secured their bows before anyone enters the downrange area.
BAI Risk Management & Mitigation 3
Which scenario represents a 'near-miss' that must be documented in archery range management?