Audi TT Audi TT Body and Interior Systems 2

Question 1

Where are the Audi TT MkII body cavity drainage holes located that must be cleared during annual maintenance?

Accepted Answer

Bottom of the doors, sill cavities, and trunk corners

Answer

The Audi TT has drain holes at the bottom of each door, in the rocker sill cavities, and in the trunk corners that must be kept clear to prevent rust and water accumulation.

Question 2

What adhesive system is used when replacing the Audi TT windshield?

Accepted Answer

OEM-approved single-component polyurethane windshield adhesive

Answer

Audi requires an OEM-approved single-component polyurethane adhesive for windshield bonding to maintain structural integrity and airbag deployment performance.

Question 3

What is the safe drive-away time after windshield replacement on the Audi TT under standard shop conditions?

Accepted Answer

At least 60 minutes or per adhesive manufacturer's specification

Answer

Polyurethane windshield adhesive requires a minimum cure time (typically 60 minutes or more at room temperature) before the vehicle can be safely driven.

Question 4

Which system must be recalibrated after replacing the Audi TT (MkIII) windshield equipped with a front camera?

Accepted Answer

Lane departure warning and forward collision assist camera

Answer

The MkIII Audi TT can be equipped with a windshield-mounted camera for driver assistance systems that require static ADAS calibration after glass replacement.

Question 5

What is the recommended method to diagnose a water leak in the Audi TT hardtop coupe cabin area?

Accepted Answer

Perform a controlled water test using a low-pressure hose and trace with a moisture meter

Answer

A controlled low-pressure water test combined with a moisture meter allows precise leak location without risking damage from high-pressure washing.

Audi TT - Certified Audi TT Specialist Practice Test

Audi TT - Certified Audi TT Specialist Practice Test

Audi TT Audi TT Body and Interior Systems 2