ATSA ATC Collision Simulation 5

Question 1

A safety alert must be issued when a controller observes an aircraft is in unsafe proximity to terrain, obstructions, or other aircraft. This alert is:

Accepted Answer

Mandatory and takes priority over other transmissions

Answer

Safety alerts are mandatory and represent a controller's highest priority transmission when a hazard is observed.

Question 2

In a simulation, an aircraft deviates from its assigned route and enters another aircraft's protected airspace. After issuing a safety alert, what is the controller's next step?

Accepted Answer

Issue resolution instructions and coordinate as necessary

Answer

After issuing a safety alert, the controller provides resolution instructions and coordinates with adjacent positions if needed.

Question 3

Which of the following scenarios represents a loss of separation in terminal radar airspace (within 40 miles of the airport)?

Accepted Answer

Two aircraft 2 miles apart laterally at the same altitude

Answer

In terminal airspace, the standard radar separation is 3 miles; 2 miles laterally at the same altitude constitutes a loss of separation.

Question 4

During conflict simulation training, recognizing 'overtake geometry' is important. This occurs when:

Accepted Answer

A faster aircraft is directly behind a slower aircraft at the same altitude on the same route

Answer

Overtake geometry involves a faster trailing aircraft closing on a slower leading aircraft; the conflict develops slowly but can be missed if not monitored.

Question 5

A controller notices a conflict on radar but is unsure if separation will actually be lost. The appropriate action is to:

Accepted Answer

Take immediate action to ensure separation while the situation is still manageable

Answer

Controllers should not wait for automation alarms; early intervention when a conflict is suspected avoids the urgency of last-minute resolution.

ATSA - Air Traffic Skills Assessment Practice Test

ATSA - Air Traffic Skills Assessment Practice Test

ATSA ATC Collision Simulation 5