Supporting Systems Flashcards
11 cards from real ASE L3 practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 11 Supporting Systems flashcards as text
A technician is replacing the HV electric A/C compressor on a hybrid vehicle. Which refrigerant oil must be used when servicing the system?
Answer: The POE (polyol ester) oil specified by the manufacturer
Electric compressors have the HV motor windings exposed to the refrigerant and oil, so they require the manufacturer-specified electrically insulating oil, typically POE. Using the wrong oil can degrade insulation and set an isolation fault.
A hybrid uses a brake-by-wire system with a stroke simulator. During a normal brake application, what is the stroke simulator's function?
Answer: It provides pedal feel while the driver's master cylinder pressure is isolated from the wheel circuits
In brake-by-wire systems the pedal's master cylinder is isolated and feeds the simulator, giving normal pedal feel. The brake ECU separately controls wheel brake pressure to blend regenerative and hydraulic braking.
After refilling the power electronics (inverter) coolant loop on a hybrid, what is the correct way to purge trapped air?
Answer: Run the electric coolant pump using a scan tool active test and top off as air is released
The inverter loop uses a separate electric pump, so the pump is run via the scan tool's active test to circulate coolant and bleed air. Level is then rechecked and topped off.
On a SAE J1772 charging connection, what information does the duty cycle of the control pilot signal communicate to the vehicle?
Answer: The maximum current the EVSE can supply
The EVSE sends a 1 kHz PWM pilot signal whose duty cycle tells the vehicle the maximum available charging current. The vehicle then limits its draw to that value.
A Level 2 EVSE is hardwired to a dedicated 240 V, 40 A branch circuit. Based on the continuous-load rule, what is the maximum continuous charging current the EVSE should be set to deliver?
Answer: 32 A
Continuous loads are limited to 80% of the breaker rating, and 80% of 40 A is 32 A.
A customer uses a Level 1 cord set with a 120 VAC household outlet. Which statement describes this charging method?
Answer: It has the slowest charging rate and is limited by the outlet circuit's capacity
Level 1 charging uses a 120 VAC outlet and is the slowest, typically about 1.4 kW at 12 A. It still goes through the onboard charger and is limited by the circuit.
What is required for a vehicle to perform true vehicle-to-grid (V2G) power export?
Answer: A bidirectional power path and a grid-compliant EVSE that can communicate with the vehicle and utility
V2G needs hardware capable of reversing power flow plus a grid-interconnection-compliant EVSE or inverter with communication. A one-way charger cannot export energy.
In an electric power steering (EPS) system, which inputs does the control module primarily use to calculate the amount of motor assist?
Answer: Steering column torque sensor signal and vehicle speed
The EPS ECU uses the torque sensor to measure driver effort and vehicle speed to scale the assist, giving more help at low speed. It then commands the assist motor accordingly.
A technician suspects an HV electric A/C compressor has an internal insulation fault. Which tool is appropriate to verify isolation between the HV terminals and the compressor housing, after the HV system is disabled?
Answer: An insulation resistance tester (megohmmeter)
An insulation tester applies a test voltage and measures very high resistances to confirm isolation. A standard multimeter cannot detect marginal insulation leakage.
A hybrid is driven down a long hill immediately after a full charge, and the driver notices little regenerative braking. What is the most likely reason?
Answer: The HV battery is at a high state of charge and cannot accept much charge
At high state of charge, the HV battery limits charge acceptance, so regenerative torque is reduced and friction brakes or engine braking take over. Cold temperature can have a similar limiting effect.
Why can a typical hybrid's air conditioning continue to operate when the gasoline engine is stopped?
Answer: The compressor has its own HV-powered electric motor controlled through an inverter
Hybrid electric compressors run from the HV system, not from an engine belt. Their speed is controlled by an inverter commanded by the A/C ECU.
How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy
Sources & references
Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy
- ase.com — Test delivery, registration deadline, test dates, eligibility, time limit, score validity · verified Nov 2026