Apprenticeship Exam Workplace Safety and OSHA Standards 2

Question 1

Which of the following is the correct action if a fire extinguisher is needed? (PASS method — first step)

Accepted Answer

Pull the pin

Answer

The PASS method begins with pulling the pin to unlock the extinguisher handle.

Question 2

What is the safe load limit called on scaffolding rated for its maximum capacity?

Accepted Answer

Working load limit

Answer

The working load limit (WLL) specifies the maximum weight the scaffold can safely support during use.

Question 3

An apprentice notices a frayed electrical cord on a power tool. What should they do first?

Accepted Answer

Tag it out of service and report it to the supervisor

Answer

Damaged tools must be taken out of service immediately and reported so they can be repaired or replaced.

Question 4

Which class of fire extinguisher is used for electrical fires?

Accepted Answer

Class C

Answer

Class C extinguishers are rated for electrical fires because they use non-conductive agents.

Question 5

How often must hard hats be inspected on a construction site?

Accepted Answer

Before each use

Answer

Hard hats should be inspected before each use for cracks, dents, or damage that could reduce protection.

Apprenticeship Exam Practice Test