Safety Devices and Regulations Flashcards

Under the Gas Safety (Installation and Use) Regulations 1998, how often must a landlord have gas appliances safety checked in a rented property?

Answer: Every 12 months

The Gas Safety (Installation and Use) Regulations 1998 require landlords to have all gas appliances, flues, and associated pipework safety checked at intervals of not more than 12 months by a Gas Safe registered engineer. A Landlord Gas Safety Record must be issued and a copy provided to tenants.

What classification should a gas engineer assign to an appliance that poses an immediate danger to life?

Answer: Immediately Dangerous (ID)

Under the Gas Industry Unsafe Situations Procedure (GIUSP), an appliance that poses an immediate danger to life or property must be classified as Immediately Dangerous (ID). The engineer must disconnect the gas supply, attach a warning label, and advise the responsible person of the danger.

What is the maximum permitted ambient air CO reading that should trigger immediate investigation according to industry guidance?

Answer: 9 ppm

While the HSE workplace exposure limit for CO is 20 ppm (8-hour TWA), industry guidance recommends that a reading of 9 ppm or above in ambient air should trigger immediate investigation of the source. Investigation should begin at lower levels to ensure occupant safety.

What is the purpose of the flame supervision device (FSD) on a gas boiler?

Answer: To shut off the gas supply if the flame is not detected

The flame supervision device, typically an ionisation probe or thermocouple, monitors the presence of the burner flame. If the flame goes out unexpectedly, the FSD signals the gas valve to close within seconds, preventing unburnt gas from accumulating which could cause an explosion.

According to BS 5440-1, what is the minimum distance a room-sealed boiler flue terminal must be from an opening window?

Answer: 300mm

BS 5440-1 specifies that a room-sealed (balanced flue) terminal must be at least 300mm from an openable window, air vent, or other opening into a building. This prevents flue products from being drawn back into the property through the opening.

What action must a Gas Safe engineer take upon discovering a gas leak during a routine service?

Answer: Immediately make the situation safe by turning off the gas supply, ventilating the area, and investigating the source

Upon discovering a gas leak, the engineer must immediately take action to make the situation safe: turn off the gas supply at the meter, ventilate the area by opening windows and doors, and investigate the source. No electrical switches should be operated. The leak must be repaired and tightness tested before restoring the supply.