Practice Test Geeks911 Operator Test Practice Test
← All 911 Operator Test Flashcard Decks

Radio Communication Protocols Flashcards

7 cards from real 911 Operator Test practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Radio Communication Protocols flashcards as text

  1. What is the purpose of a 'patch' in radio communications?

    Answer: Connecting two or more radio channels so users on each can communicate

    A patch links two different radio channels or systems together, allowing personnel on separate channels or agencies to communicate with each other.

  2. Which of the following best describes 'simplex' radio operation?

    Answer: Transmission and reception occur on the same frequency but not simultaneously

    Simplex operation uses a single frequency for both transmission and reception, meaning only one party can talk at a time.

  3. When a dispatcher says 'go ahead' after a unit calls in, what is the unit expected to do?

    Answer: Begin transmitting its full message or request

    'Go ahead' is a signal from the receiving station that it is ready to receive the calling unit's full transmission.

  4. What is the correct way to correct an error made during a radio transmission?

    Answer: Say 'correction' and then state the correct information

    The word 'correction' signals to the listener that the previous statement was an error and the information following is accurate.

  5. What is the significance of a 'dead spot' in radio coverage?

    Answer: A geographic area where radio signals are weak or unable to be received

    Dead spots are geographic areas where terrain, buildings, or distance prevent adequate radio signal reception, creating communication gaps.

  6. A unit transmits 'Show me out at [address], Code 6.' What does Code 6 typically mean in many U.S. jurisdictions?

    Answer: Officer is on scene investigating, do not disturb unless urgent

    Code 6 commonly means the officer is out of the vehicle and investigating on scene, requesting minimal radio interruption unless it is urgent.

  7. What does it mean if a dispatcher broadcasts 'all units, stand by for priority traffic'?

    Answer: Units should clear the channel and wait for an important transmission

    This announcement clears the channel of routine traffic so the important or emergency message can be broadcast without interference.