433A Pumps and Compressors 4

Question 1

What is a progressive cavity pump and what fluids is it best suited for?

Accepted Answer

A positive displacement pump using a helical rotor in a rubber stator, ideal for viscous, shear-sensitive, and solids-laden fluids

Answer

A progressive cavity pump uses a single helical rotor turning inside a double helical rubber stator, creating progressing sealed cavities that gently move fluid without pulsation. It handles viscous, abrasive, and shear-sensitive fluids including slurries and sludge.

Question 2

What is deadheading a centrifugal pump and why is it dangerous?

Accepted Answer

Operating the pump with the discharge valve closed, causing the pump to churn fluid internally and overheat rapidly

Answer

Deadheading occurs when the pump runs with the discharge closed (or severely restricted). All the input energy converts to heat in the confined fluid, causing rapid temperature rise that can vaporize the fluid, damage seals and bearings, and potentially rupture the casing.

Question 3

What type of compressor uses centrifugal force to compress gas?

Accepted Answer

Centrifugal (dynamic) compressor

Answer

A centrifugal compressor uses a high-speed rotating impeller to accelerate gas outward by centrifugal force, then converts this velocity energy to pressure in a diffuser and volute. It is used for large-volume, continuous-flow applications.

Question 4

What is the purpose of a shaft sleeve on a pump?

Accepted Answer

To protect the shaft from wear and corrosion at the packing or seal area, providing a replaceable wear surface

Answer

A shaft sleeve is a replaceable protective cover fitted over the shaft in the area where packing or seals contact it. It protects the more expensive shaft from the wear, corrosion, and erosion that occurs at the sealing area.

Question 5

What is surge in a centrifugal compressor?

Accepted Answer

An unstable operating condition where flow reverses direction periodically, causing violent pulsation and potential mechanical damage

Answer

Surge occurs when flow through a centrifugal compressor drops below a minimum value, causing a momentary flow reversal. The cycle of forward flow, stall, reversal, and recovery creates violent pressure pulsations and can cause catastrophic mechanical damage.

Red Seal Millwright 433A Practice Test

Red Seal Millwright 433A Practice Test

433A Pumps and Compressors 4