433A Alignment and Levelling 4

Question 1

What instrument is commonly used to check the flatness of a large baseplate or sole plate?

Accepted Answer

Precision machinist level and straightedge

Answer

A precision machinist level placed on a straightedge spanning the baseplate surface is the standard method for checking flatness and level of large baseplates and sole plates during installation.

Question 2

What is pipe strain and how does it affect alignment?

Accepted Answer

External forces from connected piping that distort the machine casing and shift alignment

Answer

Pipe strain occurs when connected piping exerts forces (from thermal expansion, improper supports, or poor fit-up) on the machine casing, distorting it and shifting the shaft alignment. It must be eliminated before alignment.

Question 3

When performing laser shaft alignment, why is it important to eliminate bracket sag?

Accepted Answer

Bracket sag introduces a systematic error that makes offset readings inaccurate

Answer

Bracket sag causes the indicator or laser detector to droop under gravity when rotated to the bottom position, introducing a systematic error in the offset (rim) readings. Modern laser systems often have automatic sag compensation.

Question 4

What is the acceptable alignment tolerance typically expressed in?

Accepted Answer

Mils (thousandths of an inch) for offset and mils per inch for angularity

Answer

Alignment tolerances are expressed as offset in mils (thousandths of an inch or hundredths of a millimeter) and angularity in mils per inch (or mm/100mm) of coupling span. Tolerances become tighter at higher operating speeds.

Question 5

Why is it standard practice to move only the movable machine during alignment corrections?

Accepted Answer

The stationary machine is the reference and is already aligned to process piping and other equipment

Answer

One machine (typically the driver) is designated as the 'movable' machine while the other (typically the driven equipment) is the 'stationary' reference because it is already aligned to process piping, ductwork, or other fixed connections.

Red Seal Millwright 433A Practice Test

Red Seal Millwright 433A Practice Test

433A Alignment and Levelling 4