Pumps and Equipment Maintenance Flashcards
6 cards from real Wastewater Operator Certification practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 Pumps and Equipment Maintenance flashcards as text
An operator performing a routine check on a large centrifugal pump hears a distinct noise similar to gravel or marbles rattling inside the pump casing. The discharge pressure gauge is also fluctuating erratically. What is the MOST likely cause of these symptoms?
Answer: Cavitation occurring inside the volute
The classic symptoms of cavitation are a rattling or gravelly sound caused by the formation and violent collapse of vapor bubbles against the impeller and volute walls. This process also causes fluctuations in discharge pressure and can quickly damage pump components.
A positive displacement pump, such as a progressive cavity pump, is being selected for a sludge pumping application. What is the primary advantage of using this type of pump over a centrifugal pump for this service?
Answer: It delivers a relatively constant flow rate despite changes in discharge pressure.
Positive displacement pumps move a fixed volume of fluid with each revolution. This characteristic allows them to deliver a consistent, predictable flow rate even when the downstream head or pressure changes, which is ideal for applications like feeding sludge to a dewatering unit.
Upon finding a pump motor that is excessively hot and drawing amps significantly above its nameplate rating, what is the correct IMMEDIATE action an operator should take?
Answer: Immediately shut down, lock out, and tag out the equipment.
Safety is the first priority. An overheated motor with a high amperage draw indicates a serious problem (e.g., clog, bearing failure, electrical fault) that poses a safety risk. The equipment must be safely de-energized using proper lockout/tagout procedures before any troubleshooting or investigation can begin.
Which of the following is the primary purpose of a mechanical seal on a centrifugal pump?
Answer: To control leakage where the rotating shaft exits the stationary pump casing.
A mechanical seal is a device used to contain fluid within a vessel (the pump casing) where a rotating shaft passes through a stationary housing. It uses two extremely flat, lapped faces—one rotating and one stationary—to prevent significant leakage while allowing the shaft to spin freely.
During the replacement of pump packing in a stuffing box, an operator must ensure the lantern ring is correctly positioned. What is the critical function of the lantern ring?
Answer: To provide a pathway for seal water to lubricate and cool the packing and shaft.
The lantern ring is a perforated ring placed between rings of packing. It must be aligned with the seal water port to allow clean water to be distributed around the pump shaft. This water serves to lubricate the packing, cool the shaft, and flush away any abrasive particles, preventing damage.
Which of the following routine maintenance tasks is MOST critical for ensuring the long-term health of an electric motor's bearings?
Answer: Adhering to a proper lubrication schedule with the correct type and amount of grease.
The leading cause of premature motor bearing failure is improper lubrication. This includes both under-lubrication (causing excessive friction and heat) and over-lubrication (which can damage seals and cause overheating). Following the manufacturer's recommended schedule, grease type, and volume is essential for longevity.