Walmart Maintenance Technician 2 — Questions and Answers
Question 1: A conveyor belt at a Walmart distribution center keeps slipping under load. What is the most likely first thing a maintenance technician should check?
- Belt tension and alignment (Correct answer)
- The store's Wi-Fi signal
- The fire alarm panel
- The parking lot lighting
Correct answer: Belt tension and alignment
Belt slippage under load is most commonly caused by improper tension or misalignment.
Question 2: Before performing electrical repairs on a piece of store equipment, what safety procedure must be followed?
- Lockout/Tagout (LOTO) (Correct answer)
- Clocking out for lunch
- Notifying the marketing team
- Restocking the shelves
Correct answer: Lockout/Tagout (LOTO)
Lockout/Tagout isolates energy sources to prevent accidental startup during repairs.
Question 3: A walk-in freezer is not maintaining temperature. Which component should a technician inspect first?
- The condenser and evaporator coils (Correct answer)
- The shopping cart corral
- The checkout scanners
- The store signage
Correct answer: The condenser and evaporator coils
Dirty or iced-over coils are a common cause of poor refrigeration performance.
Question 4: What is the primary purpose of preventive maintenance on store equipment?
- Reduce unexpected breakdowns and extend equipment life (Correct answer)
- Increase electricity bills
- Slow down the work pace
- Replace all equipment yearly
Correct answer: Reduce unexpected breakdowns and extend equipment life
Preventive maintenance catches small issues before they cause costly failures.
Question 5: A technician notices a hydraulic pallet jack leaking fluid. What is the appropriate action?
- Tag it out of service and repair or replace the seal (Correct answer)
- Keep using it until it fully fails
- Ignore the leak
- Add water to the reservoir
Correct answer: Tag it out of service and repair or replace the seal
A leaking pallet jack is a safety hazard and should be removed from service until repaired.
Question 6: Which tool is best for measuring electrical voltage at an outlet or circuit?
- Multimeter (Correct answer)
- Torque wrench
- Caulking gun
- Stud finder
Correct answer: Multimeter
A multimeter measures voltage, current, and resistance in electrical circuits.
Question 7: An automatic sliding entrance door fails to open for customers. What should the technician check first?
- The motion sensor and door track (Correct answer)
- The store's cash registers
- The bakery oven
- The employee break room
Correct answer: The motion sensor and door track
Sliding door failures are usually due to faulty sensors or obstructed tracks.
Walmart Maintenance Technician 2
A conveyor belt at a Walmart distribution center keeps slipping under load.
What is the most likely first thing a maintenance technician should check?