WALMART MAINTENANCE Safety and Compliance 4 — Questions and Answers
Question 1: What does the acronym PPE stand for in a maintenance safety context?
- Personal Protection Equipment
- Personal Protective Equipment (Correct answer)
- Preventive Protection Equipment
- Professional Protective Equipment
Correct answer: Personal Protective Equipment
PPE stands for Personal Protective Equipment, which includes gloves, goggles, hard hats, and other gear that protects workers from hazards.
Question 2: A forklift has a rated capacity of 4,000 lbs. The load center is at 30 inches. If you move the load center to 36 inches, the actual capacity will:
- Remain the same
- Increase proportionally
- Decrease (Correct answer)
- Double
Correct answer: Decrease
As load center distance increases, the effective lifting capacity decreases because the lever arm extends, reducing the forklift's stability and rated capacity.
Question 3: Which color is OSHA-compliant for marking physical hazards such as stumbling and tripping hazards on the floor?
- Red
- Blue
- Yellow (Correct answer)
- Green
Correct answer: Yellow
Yellow is the OSHA-standard color for marking caution and physical hazards including trip hazards, aisle edges, and equipment boundaries.
Question 4: When must a maintenance employee complete an incident report after a workplace injury?
- Within 72 hours
- At the end of the current shift
- As soon as possible, ideally the same day (Correct answer)
- Within 30 days
Correct answer: As soon as possible, ideally the same day
Incident reports should be completed as soon as possible after an injury while details are fresh, typically the same day the incident occurs.
Question 5: A maintenance technician is about to work on a 480V electrical panel. Which minimum PPE is required?
- Safety glasses and leather gloves
- Arc flash suit, face shield, and insulated gloves rated for the voltage (Correct answer)
- Hard hat and steel-toe boots only
- Chemical-resistant apron and goggles
Correct answer: Arc flash suit, face shield, and insulated gloves rated for the voltage
Work on 480V electrical panels requires arc-flash-rated PPE including an arc flash suit, face shield, and voltage-rated insulated gloves per NFPA 70E standards.
Question 6: Which regulatory agency primarily oversees workplace safety standards for Walmart maintenance employees?
- EPA
- OSHA (Correct answer)
- NFPA
- ANSI
Correct answer: OSHA
OSHA (Occupational Safety and Health Administration) is the federal agency responsible for enforcing workplace safety and health regulations.
Question 7: What is the correct procedure when a fire alarm sounds during a maintenance task involving open equipment?
- Finish the current step before evacuating
- Attempt to close or secure equipment then evacuate immediately
- Evacuate immediately, leaving equipment as-is if safe to do so (Correct answer)
- Call a supervisor before evacuating
Correct answer: Evacuate immediately, leaving equipment as-is if safe to do so
On a fire alarm, immediate evacuation takes priority; if it can be done safely in seconds, secure obvious hazards, but personal safety outweighs equipment protection.
WALMART MAINTENANCE Safety and Compliance 4
What does the acronym PPE stand for in a maintenance safety context?