Practice Test Geeks(SPED) Society of Piping Engineers and Designers Certification Practice Test
← All SPED Flashcard Decks

Codes, Regulations & Safety Practices Flashcards

7 cards from real SPED practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Codes, Regulations & Safety Practices flashcards as text

  1. According to ASME B31.3, what examination method is mandatory for all circumferential butt welds in Category M (Severe Cyclic Conditions) fluid service?

    Answer: 100% radiographic or ultrasonic examination

    ASME B31.3 requires 100% radiographic or ultrasonic examination of circumferential butt welds in Category M severe cyclic service.

  2. EPA's Risk Management Program (RMP) under 40 CFR Part 68 requires facilities to develop an emergency response plan when they have what type of covered process?

    Answer: A Program 2 or Program 3 covered process

    Facilities with Program 2 or Program 3 covered processes under 40 CFR Part 68 must develop and implement an emergency response program.

  3. What is the purpose of a Piping and Instrumentation Diagram (P&ID) safety review in the context of HAZOP studies?

    Answer: To systematically identify potential deviations from design intent that could cause hazards

    HAZOP (Hazard and Operability) studies use P&IDs to systematically identify potential deviations from design intent that could create safety or operability hazards.

  4. Under ASME B31.4 Pipeline Transportation Systems for Liquids, what is the maximum hoop stress allowed as a percentage of SMYS in Class 1 locations?

    Answer: 72%

    ASME B31.4 allows a maximum hoop stress of 72% of SMYS (Specified Minimum Yield Strength) for liquid pipelines in Class 1 locations.

  5. Which NFPA standard specifically addresses the installation of sprinkler systems and is most relevant to fire protection piping design?

    Answer: NFPA 13

    NFPA 13, Standard for the Installation of Sprinkler Systems, governs the design and installation of fire protection sprinkler piping.

  6. In the context of OSHA 29 CFR 1910.147 Lockout/Tagout (LOTO), which energy source must be controlled when performing maintenance on a pressurized piping system?

    Answer: All hazardous energy sources including stored pressure energy

    OSHA LOTO standard requires control of all hazardous energy sources, including stored pressure energy in piping systems, before maintenance begins.

  7. API RP 580 Risk-Based Inspection (RBI) methodology is used primarily to:

    Answer: Prioritize inspection resources based on probability and consequence of failure

    API RP 580 provides guidelines for risk-based inspection programs that prioritize inspection resources based on the probability and consequence of equipment failure.