Solidworks Sheet Metal and Weldments 1

Question 1

Which SolidWorks Sheet Metal feature creates the initial thin-walled base from a sketch?

Accepted Answer

Base Flange/Tab

Answer

Base Flange/Tab is the first sheet metal feature that establishes the part's thickness and initial flat geometry.

Question 2

What does the 'Flat Pattern' feature do in SolidWorks Sheet Metal?

Accepted Answer

Unfolds all bends in the sheet metal part to show the flat blank shape

Answer

Flat Pattern unfolds the sheet metal part into its flat blank state, including bend allowances for accurate manufacturing.

Question 3

In SolidWorks Sheet Metal, what is 'K-Factor' used for?

Accepted Answer

Defining the neutral axis position to calculate accurate bend allowances

Answer

K-Factor defines where the neutral bend axis sits within the material thickness, directly affecting flat pattern accuracy.

Question 4

Which sheet metal feature in SolidWorks adds a flange along a single straight edge of an existing sheet metal face?

Accepted Answer

Edge Flange

Answer

Edge Flange bends a new flange perpendicular to (or at a defined angle from) a selected straight edge of a sheet metal part.

Question 5

What is a 'Jog' feature used for in SolidWorks Sheet Metal?

Accepted Answer

Creates two bends that offset a section of the sheet metal part to a new elevation

Answer

A Jog creates two opposing bends from a sketched line to offset part of a flange up or down by a specified distance.

Solidworks Practice Test