Solidworks Sheet Metal and Weldments 2 — Questions and Answers
Question 1: Which SolidWorks Sheet Metal feature creates a folded flange along multiple connected edges simultaneously with mitered corners?
- Edge Flange
- Base Flange
- Miter Flange (Correct answer)
- Swept Flange
Correct answer: Miter Flange
Miter Flange adds a continuous flange along a series of connected edges, automatically mitering the corners.
Question 2: In SolidWorks, what is a 'Weldment' used for?
- Simulating the heat-affected zone of a weld
- Creating structural members like beams, tubes, and pipes along 2D and 3D sketch paths (Correct answer)
- Generating weld symbols on a drawing
- Defining fillet welds in a sheet metal assembly
Correct answer: Creating structural members like beams, tubes, and pipes along 2D and 3D sketch paths
Weldments use structural member profiles from a library applied along sketch paths to build frames and structures.
Question 3: Which SolidWorks Weldments feature is used to trim or extend structural members to meet correctly at joints?
- Split Bodies
- Weld Bead
- Trim/Extend (Correct answer)
- End Cap
Correct answer: Trim/Extend
The Trim/Extend feature cuts or extends weldment structural members so they meet cleanly at frame junctions.
Question 4: What does a 'Cut List' provide in a SolidWorks Weldment?
- A list of all weld beads with their lengths
- A table of all structural members grouped by profile type and length for fabrication (Correct answer)
- A bill of materials for hardware attached to the frame
- A list of all sketch entities used to define the weldment paths
Correct answer: A table of all structural members grouped by profile type and length for fabrication
The Cut List groups weldment bodies by profile and length, providing the quantities needed for cutting material for fabrication.
Question 5: Which SolidWorks Sheet Metal feature rolls an edge over on itself to create a safe, smooth edge?
- Jog
- Louver
- Hem (Correct answer)
- Vent
Correct answer: Hem
The Hem feature rolls or folds the edge of a sheet metal part back on itself to eliminate sharp edges.
Question 6: What is the purpose of 'Relief' cuts in SolidWorks Sheet Metal bends?
- Decorative slots added to the bend area
- Small cuts at the ends of bends to prevent material tearing during forming (Correct answer)
- Openings that allow the flat pattern to fold correctly in the press brake
- Stress-relief holes drilled near the bend line
Correct answer: Small cuts at the ends of bends to prevent material tearing during forming
Relief cuts prevent the material from tearing at the end of a bend by providing a stress-relieving slot.
Solidworks Sheet Metal and Weldments 2
Which SolidWorks Sheet Metal feature creates a folded flange along multiple connected edges simultaneously with mitered corners?