Solidworks Routing (Piping, Tubing, and Electrical)

Question 1

In SolidWorks Routing, what is a 'Route Point' (Rp) used for?

Accepted Answer

A sketch point that defines where a pipe segment begins, ends, or changes direction

Answer

A Route Point (Rp) is a 3D sketch point that drives the path of a pipe or tube route. SolidWorks uses Rp points to define start/end locations and direction changes, and fittings are snapped to these points when the route is built.

Question 2

Which SolidWorks Routing sub-type is used for flexible hoses that can follow a curved, non-linear path between two connection points?

Accepted Answer

Flexible Tube Routing

Answer

Flexible Tube Routing in SolidWorks is designed for hoses and tubes that bend along a spline path, unlike rigid pipe routes which use straight segments connected by fittings at angular changes.

Question 3

In SolidWorks Electrical Routing, what file type defines the properties (wire gauge, insulation color, bend radius) of a cable or harness segment?

Accepted Answer

Wire/Cable Library file (.xml)

Answer

SolidWorks Electrical Routing uses XML-based wire and cable library files to store electrical properties such as wire gauge, number of conductors, insulation material, and minimum bend radius that are then applied to route segments.

Question 4

When starting a pipe route in SolidWorks Routing from a flange connection point, what happens automatically once you drag a routing component (e.g., an elbow fitting) onto an existing pipe end?

Accepted Answer

A 3D sketch segment is automatically inserted and the fitting mates to the pipe end

Answer

SolidWorks Routing is highly automated: when you drag a compatible fitting onto a connection point (Cp), a 3D route sketch segment is automatically inserted, the fitting is mated using its own connection points, and the pipe run geometry updates accordingly.

Question 5

In a SolidWorks routing assembly, which specialized assembly feature stores all the 3D sketch route paths, pipe bodies, and fittings as a distinct sub-assembly?

Accepted Answer

Route Sub-Assembly

Answer

SolidWorks Routing automatically creates a Route Sub-Assembly (.sldasm) within the top-level assembly to contain all route segments, fittings, and the 3D sketch that defines the path, keeping routing geometry organized and separate from structural components.

Solidworks Practice Test

Solidworks Practice Test

Solidworks Routing (Piping, Tubing, and Electrical)