Solidworks Motion Studies and Animation

Question 1

In SolidWorks, which Motion Study type uses actual mass properties, gravity, and contact conditions to calculate physically accurate forces and displacements?

Accepted Answer

Motion Analysis

Answer

Motion Analysis uses the SolidWorks Motion add-in (powered by ADAMS solver) to apply real physics — gravity, contact, springs, dampers, and motors — and computes accurate forces, velocities, and displacements that can be used in downstream analysis.

Question 2

In a SolidWorks Motion Study, which element is used to apply a rotating force that drives a mechanism at a specified angular velocity?

Accepted Answer

Rotary Motor

Answer

A Rotary Motor in a Motion Study applies a rotational driver to a component face or edge, controlling it by constant RPM, oscillating, or expression-based velocity — simulating an actual motor driving a mechanism.

Question 3

What is the purpose of the 'Key Point' (diamond icon) on the SolidWorks Motion Study timeline?

Accepted Answer

It defines the position, orientation, or visibility state of a component at a specific time

Answer

Key points on the Motion Study timeline define the state (position, orientation, display state, etc.) of a component at a specific moment. SolidWorks interpolates between key points to create smooth transitions during playback or export.

Question 4

In the SolidWorks 'Basic Motion' study type, which physical effect is available that is NOT available in the 'Animation' study type?

Accepted Answer

Gravity and component contact

Answer

Basic Motion adds a simplified physics layer over Animation, allowing gravity, springs, and solid-body contact to drive component motion. Animation only moves components by manually defined key points and motor speeds, with no physical interaction simulation.

Question 5

After running a Motion Analysis in SolidWorks, where do you go to plot a graph of a joint reaction force over time?

Accepted Answer

Motion Study Results > Create New Plot

Answer

After a Motion Analysis run, the Results section of the MotionManager allows you to create new result plots (force, velocity, acceleration, torque, etc.) as time-history graphs directly within the motion study environment.

Solidworks Practice Test

Solidworks Practice Test

Solidworks Motion Studies and Animation