Practice Test Geeks(SMSTS) Site Management Safety Training Scheme Practice Test
← All SMSTS Flashcard Decks

Technical Standards and Specifications Flashcards

7 cards from real SMSTS practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Technical Standards and Specifications flashcards as text

  1. Under the SMSTS framework, which document formally identifies and records all significant health and safety risks for a construction project?

    Answer: Construction Phase Plan

    The Construction Phase Plan is the CDM-required document that records significant risks, management arrangements, and control measures for the construction phase.

  2. Per ASTM E119, what standard fire resistance rating is typically required for structural steel beams supporting floor assemblies in multi-story commercial construction?

    Answer: 2 hours

    ASTM E119 fire resistance tests support building code requirements that typically mandate a 2-hour fire rating for structural steel members in multi-story commercial buildings.

  3. What is the primary purpose of a Method Statement in construction site management?

    Answer: To detail step-by-step procedures for safely completing a specific task

    A Method Statement is a written document that describes how a specific task will be carried out safely, including sequence of operations, equipment, and hazard controls.

  4. According to OSHA 1926.502(d), what maximum arresting force is allowed on a worker's body during a fall arrest?

    Answer: 1,800 lbs

    OSHA 1926.502(d) limits the maximum arresting force to 1,800 lbs to prevent injury from the deceleration forces during a fall arrest event.

  5. Under ASME A17.1, what safety inspection frequency is required for construction hoists (personnel/material elevators)?

    Answer: Daily before each shift

    Construction hoists must be inspected before each shift by a competent person to ensure all safety devices, brakes, and controls are functioning properly.

  6. Which OSHA standard specifically addresses silica dust exposure limits and control measures for construction operations?

    Answer: 29 CFR 1926.1153

    29 CFR 1926.1153 is OSHA's construction-specific silica standard, establishing a PEL of 50 μg/m³ and requiring written exposure control plans.

  7. Per ANSI/ASSE A10.32, what is the minimum breaking strength requirement for a fall protection anchor point used in construction?

    Answer: 5,000 lbs

    ANSI/ASSE A10.32 and OSHA 1926.502 both require fall protection anchor points to support a minimum of 5,000 lbs per attached worker.