SBCA Safety Standards 5

Question 1

What is the NEC requirement for the minimum wire gauge of a satellite dish grounding conductor?

Accepted Answer

10 AWG minimum for most residential installations

Answer

NEC Article 810 requires a minimum 10 AWG copper grounding conductor for satellite dish installations in most residential scenarios.

Question 2

Which OSHA standard specifically applies to fall protection requirements for general industry workers, including satellite installers working at heights?

Accepted Answer

OSHA 1910.23 and 1910.29

Answer

OSHA 1910.23 (Ladders) and 1910.29 (Fall Protection Systems) govern fall protection for general industry workers at elevated heights.

Question 3

A technician is asked to install a satellite dish on a building with asbestos-containing roofing materials. The correct procedure is to:

Accepted Answer

Halt work and consult with the building owner about asbestos abatement before drilling or disturbing any materials

Answer

Disturbing asbestos-containing materials releases dangerous fibers requiring proper abatement by licensed contractors before any work that may disturb those materials.

Question 4

What is the purpose of equipotential bonding in a satellite installation?

Accepted Answer

To connect all conductive components to the same electrical potential, preventing dangerous voltage differences

Answer

Equipotential bonding connects all metallic components to the same ground reference, preventing voltage differences that could cause electric shock or equipment damage.

Question 5

When should a satellite dish installation site's Job Hazard Analysis (JHA) be completed?

Accepted Answer

Before work begins to identify and mitigate hazards proactively

Answer

A JHA must be completed before work begins to identify potential hazards and establish safe work procedures for each task.

(SBCA) Satellite Broadcasting and Communications Association Certification Practice Test

(SBCA) Satellite Broadcasting and Communications Association Certification Practice Test

SBCA Safety Standards 5