Wind Power Technologies Flashcards
6 cards from real REP practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 Wind Power Technologies flashcards as text
A wind turbine project is being planned for a site with highly variable wind speeds. To maximize energy capture and ensure the turbine's structural integrity, which control system is most critical for adjusting the aerodynamic forces on the blades in response to changing wind conditions?
Answer: Blade pitch control system
The blade pitch control system is essential for modern large wind turbines. It adjusts the angle of the blades relative to the wind. In low to moderate winds, it optimizes the angle for maximum energy capture. In very high winds, it 'feathers' the blades (turns them parallel to the wind) to reduce aerodynamic forces, protect the turbine from damage, and stop the rotor.
According to Betz's Law, what is the theoretical maximum percentage of kinetic energy that a wind turbine can extract from the wind?
Answer: 59.3%
Betz's Law, published by German physicist Albert Betz in 1919, states that no wind turbine can capture more than 16/27 (approximately 59.3%) of the kinetic energy in wind. If a turbine were 100% efficient, it would stop the air completely, preventing any further airflow through the rotor.
A key challenge in integrating large-scale wind power into the electrical grid is its variability. Which of the following is a primary technical challenge for grid operators resulting from this characteristic?
Answer: Maintaining grid stability and balancing supply with demand
The intermittent and variable nature of wind means that power generation can fluctuate significantly and unpredictably. This creates a major challenge for grid operators who must constantly balance electricity supply with consumer demand to maintain grid stability and reliability.
In a horizontal-axis wind turbine (HAWT), what is the primary function of the yaw control system?
Answer: To orient the rotor to face directly into the wind.
The yaw control system is responsible for orienting the turbine's nacelle and rotor to be perpendicular to the direction of the wind. This alignment is crucial to maximize the capture of wind energy and reduce mechanical stress on the turbine structure.
When comparing direct-drive wind turbines to traditional geared-drive turbines, what is a significant advantage of the direct-drive design?
Answer: Higher reliability and lower maintenance due to fewer moving parts
Direct-drive turbines eliminate the need for a gearbox, which is a complex mechanical component prone to wear and failure. By connecting the rotor directly to the generator, these turbines have fewer moving parts, leading to increased reliability, reduced maintenance requirements, and lower operational noise.
The operating range of a wind turbine is defined by its cut-in and cut-out speeds. What does the 'cut-out' speed signify?
Answer: The maximum wind speed at which the turbine safely shuts down to prevent damage.
The cut-out speed is the maximum safe operating wind speed for a turbine, typically around 25 m/s. When winds exceed this speed, the turbine's control system will automatically shut it down by feathering the blades and applying brakes to prevent excessive mechanical stress and potential damage to the structure.