Practice Test GeeksRed Seal Electrician 309A Practice Test
← All 309A Flashcard Decks

Motor Controls Flashcards

6 cards from real 309A practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 6 Motor Controls flashcards as text

  1. What is the maximum overcurrent protection permitted for a motor branch circuit with a full-load current of 40 A using an inverse-time circuit breaker?

    Answer: 100 A

    CEC Rule 28-200 permits inverse-time circuit breakers to be sized up to 250% of the motor FLC for standard motors. 40 A × 2.50 = 100 A maximum.

  2. What is the purpose of a motor overload relay?

    Answer: To protect the motor against sustained overcurrent conditions

    Overload relays protect motors from sustained overcurrent conditions (overloads) that would cause overheating and insulation damage. They are sized based on the motor's nameplate FLA.

  3. In a three-phase motor starter, what is the function of the holding coil (contactor coil)?

    Answer: To keep the contactor contacts closed after the start button is released

    The holding coil (contactor coil) creates a magnetic field that holds the main contacts closed after the start pushbutton is released, maintaining the circuit through a seal-in auxiliary contact.

  4. What is the standard overload relay trip setting for a motor with a nameplate FLA of 28 A and a 1.15 service factor?

    Answer: 32.2 A

    For motors with a service factor of 1.15 or greater, the overload relay is set at 125% of nameplate FLA: 28 × 1.25 = 35 A. However, the standard setting is typically 115%, giving 28 × 1.15 = 32.2 A per CEC requirements.

  5. What type of motor starter reduces the starting current to approximately one-third of the full-voltage starting current?

    Answer: Wye-delta starter

    A wye-delta starter connects the motor windings in wye during starting, reducing the voltage across each winding by 1/√3, which reduces starting current to approximately 33% (one-third) of DOL current.

  6. What is the purpose of a jog function on a motor controller?

    Answer: To momentarily energize the motor for precise positioning

    The jog function allows the operator to momentarily energize the motor for short bursts without latching the contactor, enabling precise positioning of machinery or loads.