Pipefitter Blueprint and Drawing Interpretation 4

Question 1

On a piping isometric drawing, what does a dashed circle at a pipe end typically indicate?

Accepted Answer

A flanged connection going into a wall or underground

Answer

A dashed circle on an isometric represents a flanged connection that is hidden from view, such as going underground or into a structure.

Question 2

What does the abbreviation 'BOP' stand for on piping drawings?

Accepted Answer

Bottom of Pipe

Answer

BOP stands for Bottom of Pipe and is used to indicate elevations measured from the lowest point of the pipe exterior.

Question 3

A piping plan drawing shows a line with alternating long and short dashes. This typically represents:

Accepted Answer

A buried or underground pipe

Answer

A hidden or buried pipe is conventionally shown with a long-short dashed line pattern on plan drawings.

Question 4

On a P&ID, what does a diamond shape on an instrument signal line indicate?

Accepted Answer

A signal conversion or conditioning device

Answer

A diamond on an instrument signal line represents a computing or signal conversion device such as a transducer or converter.

Question 5

A drawing note states 'TYP. 4 PL.' next to a support detail. What does this mean?

Accepted Answer

The detail applies to 4 places on the drawing

Answer

'TYP. 4 PL.' means 'typical, 4 places,' indicating the same detail applies at four separate locations on the drawing.

Certified Pipefitter Practice Test