PASMA Tower Inspection Procedures 1

Question 1

What are the three occasions when a tower scaffold must be inspected under UK law?

Accepted Answer

Before first use, after any event affecting stability, and at intervals not exceeding 7 days

Answer

The Work at Height Regulations 2005, Schedule 6, requires inspection before first use on site, after any event that could affect stability (e.g., adverse weather, accidental impact), and at regular intervals not exceeding 7 days.

Question 2

What is the first thing an inspector should check when inspecting a tower scaffold?

Accepted Answer

That the tower is erected on a firm, level base and the foundation is adequate

Answer

The foundation is the starting point for any inspection as everything above depends on it. The base must be on firm, level ground capable of supporting the total load. Adjustable legs or base plates should be properly set.

Question 3

During an inspection, what should be checked about the guard rails?

Accepted Answer

That they are at the correct height (minimum 950mm), securely fixed, and free from defects

Answer

Guard rails must be at least 950mm above the platform, securely locked or clipped into position, and free from bends, cracks, or corrosion that could weaken them. An intermediate rail must also be fitted to reduce gaps to 470mm maximum.

Question 4

What should an inspector do if they find a defect during a tower scaffold inspection?

Accepted Answer

Immediately take the tower out of service, report the defect, and ensure it is rectified before further use

Answer

Any defect that compromises safety must result in the tower being immediately taken out of service (e.g., with 'Do Not Use' signs). The defect must be reported and rectified by a competent person before the tower can be used again.

Question 5

What information must be recorded on a tower scaffold inspection report?

Accepted Answer

The location, date, tower details, inspector name, results of the inspection, and any defects or actions required

Answer

A comprehensive inspection report must include the tower location, date and time of inspection, tower identification, name and signature of the competent inspector, detailed findings, any defects identified, and actions taken or required.

PASMA Practice Test

PASMA Practice Test

PASMA Tower Inspection Procedures 1