PASMA Stability and Outriggers 3

Question 1

What is the danger of using a tower scaffold on a slope without proper precautions?

Accepted Answer

The tower's centre of gravity shifts towards the downhill side, dramatically increasing the risk of overturning

Answer

On a slope, the tower's centre of gravity shifts towards the lower side, reducing the restoring moment on that side. The adjustable legs must be used to level the tower, and brakes must be reliable. If the slope is too steep, the tower should not be used.

Question 2

What is the purpose of base plates on a tower scaffold?

Accepted Answer

To distribute the load over a wider area and prevent the legs from sinking into the ground

Answer

Base plates spread the concentrated load from the tower legs over a larger area, reducing the pressure on the ground surface. Without them, the legs could punch into soft ground, causing the tower to become unlevel and unstable.

Question 3

What are sole boards and when should they be used?

Accepted Answer

Timber boards placed under base plates on soft ground to further distribute the load and prevent sinking

Answer

Sole boards are timber planks (typically scaffold boards) placed under the base plates when the ground is soft, such as on grass, recently filled ground, or muddy surfaces. They further spread the load to prevent the tower from sinking unevenly.

Question 4

What happens to tower stability if one castor brake fails while operatives are working on the platform?

Accepted Answer

The tower could roll or swivel on the failed castor, potentially overturning, especially if the operative is working at the platform edge

Answer

A failed brake allows the tower to move on that castor. If an operative applies a horizontal force (e.g., reaching out), the tower could roll or rotate about the locked castors, leading to a loss of balance and potential overturning.

Question 5

Why should sheeting or tarpaulins NOT be attached to a tower scaffold without authorisation?

Accepted Answer

Because they dramatically increase the wind-catching surface area, increasing the overturning moment and risk of collapse

Answer

Sheeting, tarpaulins, banners, or any large-area material significantly increases the surface area exposed to wind, creating much greater wind forces. This dramatically increases the overturning moment and can cause the tower to collapse in even moderate winds.

PASMA Practice Test

PASMA Practice Test

PASMA Stability and Outriggers 3