Earthing & Bonding Flashcards
6 cards from real PART P practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 Earthing & Bonding flashcards as text
What is an earth electrode?
Answer: A conductor buried in the ground to provide a connection between the installation's earthing system and the general mass of earth — used in TT systems
An earth electrode (commonly a steel rod driven into the ground) provides the earth connection for TT installations where the supply network does not provide a direct earth; its resistance must be low enough for the protective device (usually an RCD) to operate.
What instrument is used to measure the resistance of an earth electrode?
Answer: An earth electrode resistance tester (using the 3-probe or 4-probe method)
Earth electrode resistance is measured using a dedicated earth electrode tester (fall of potential method, 3-probe), which injects a current into the earth and measures the voltage drop to calculate resistance.
What is a typical maximum acceptable resistance for an earth electrode in a TT installation to ensure RCD operation?
Answer: The electrode resistance plus any bonding resistance must be such that the RCD trips at its rated current — typically below 200 Ω for a 30 mA RCD (at 50 V / 0.03 A = 1667 Ω absolute maximum, but practically much lower)
For a 30 mA RCD to operate, the touch voltage must reach approximately 50 V; with 30 mA through an earth path, Ohm's law gives a maximum resistance of 50/0.03 ≈ 1667 Ω — but practically, electrode resistance should be much lower for reliable operation.
What is 'parallel earth paths' and why can they cause problems?
Answer: Multiple unintended paths for earth fault current (e.g., via water pipes, structural steel) that can cause current to flow in unintended conductors, increasing fire risk and causing inaccurate test results
Parallel earth paths can allow fault current to flow via unintended routes (e.g., through metallic pipework) rather than through the CPC, causing heating of those conductors and giving misleadingly low Zs test readings.
What is the purpose of an earth continuity test on a portable appliance (PAT test)?
Answer: To verify the earth conductor within the appliance flex and its connection to the appliance metalwork are continuous and have a low resistance
The earth continuity test in PAT testing confirms the appliance's earth conductor is intact from the plug earth pin through the flex to all earthed metalwork of the appliance, ensuring protection against shock if a fault occurs.
What hazard can arise from a broken CPC (earth conductor) in a circuit?
Answer: If a fault causes a live conductor to contact exposed metalwork, the metalwork will remain live at dangerous voltage as there is no path for fault current to operate the protective device
A broken CPC means exposed metalwork is not earthed; a fault energising the metalwork creates a dangerous live surface that will not trip the protective device (no fault current path), creating a sustained shock risk.