SD CDL - South Dakota Commercial Drivers License Combination Vehicle Operations Questions and Answers

Question 1

You are driving a combination vehicle and make a sudden lane change. What is the 'crack-the-whip' effect?

Accepted Answer

The tendency of the rear trailer to swing out with greater force than the tractor.

Answer

The 'crack-the-whip' effect, also known as rearward amplification, occurs when a driver makes a quick steering maneuver. The force is magnified down the length of the combination vehicle, causing the rearmost trailer to swing out more dramatically than the tractor, which can lead to a rollover of the trailer.

Question 2

When coupling a tractor to a semitrailer, what is the correct height for the trailer?

Accepted Answer

The trailer will be raised slightly when the tractor is backed under it.

Answer

The trailer should be set at a height where backing the tractor under it causes the trailer to be lifted slightly. This ensures a secure connection with the fifth wheel and prevents damage to the landing gear or the tractor.

Question 3

Which of the following is a primary factor that contributes to the rollover risk of combination vehicles?

Accepted Answer

A high center of gravity.

Answer

A high center of gravity is a major reason why combination vehicles are prone to rollovers. The higher the load is stacked, the higher the center of gravity, making the vehicle less stable, especially in turns or during sudden maneuvers.

Question 4

A driver is operating a combination vehicle with a dual air brake system. With the engine off and the brakes released, what is the maximum allowable air pressure leakage rate per minute?

Accepted Answer

3 PSI

Answer

For a combination vehicle, the Federal Motor Carrier Safety Administration (FMCSA) regulations state that the air pressure drop should not exceed 3 PSI in one minute when the engine is off and the service brakes are released.

Question 5

While uncoupling a trailer, after you have lowered the landing gear and disconnected the air and electrical lines, what is the next step?

Accepted Answer

Unlock the fifth wheel by pulling the release handle.

Answer

After lowering the landing gear and disconnecting the lines, the next step is to unlock the fifth wheel. This is done by pulling the release handle, which disengages the locking jaws from the trailer's kingpin, preparing the tractor to be pulled away.

SD CDL - South Dakota Commercial Drivers License Practice Test

SD CDL - South Dakota Commercial Drivers License Practice Test

SD CDL - South Dakota Commercial Drivers License Combination Vehicle Operations Questions and Answers