SAMS - Society of Accredited Marine Surveyors Certified Vessel Electrical Systems Questions and Answers

Question 1

A surveyor inspecting a vessel connected to shore power notices rapid zinc anode depletion. The shore power system includes a green grounding wire connecting the vessel's bonding system to the marina's ground. According to ABYC standards, what device should be installed in the grounding conductor to mitigate this issue while maintaining safety?

Accepted Answer

A galvanic isolator

Answer

A galvanic isolator is specifically designed to block low-voltage DC galvanic currents that cause rapid anode depletion and corrosion, while still allowing the AC safety ground to function in the event of a fault. An isolation transformer would also solve the problem but is a more comprehensive and expensive solution. A reverse polarity indicator warns of incorrect wiring, and a Class-T fuse provides overcurrent protection; neither addresses galvanic corrosion.

Question 2

During a survey of a 35-foot recreational vessel's DC electrical system, you discover several connections in the bilge area made with twist-on wire nuts and wrapped in electrical tape. Which of the following best describes this finding based on ABYC E-11 standards?

Accepted Answer

A significant deficiency, as wire nuts are not permitted for DC connections in marine environments.

Answer

ABYC E-11 standards explicitly prohibit the use of twist-on wire nuts for DC wiring connections. The marine environment, with its inherent moisture and vibration, can cause wire nuts to loosen, trap moisture, and lead to corrosion and unsafe connections. The standard requires the use of mechanically secure, crimped connectors, typically sealed with heat shrink tubing.

Question 3

According to ABYC standards for DC wiring color codes, which color wire should a surveyor expect to find connected to the negative main conductor?

Accepted Answer

Black or Yellow

Answer

ABYC standards specify that Black or Yellow wire is used for the negative main conductors in a DC system. Red is used for the positive main. Green or Green with a yellow stripe is for the bonding/grounding system. Purple is typically used for ignition switch circuits.

Question 4

A surveyor is inspecting the installation of a new lithium-ion (LiFePO4) house battery bank. According to ABYC E-13, which of the following is a mandatory requirement for the installation?

Accepted Answer

The system must include a Battery Management System (BMS) to protect against overcharging and other unsafe conditions.

Answer

The ABYC E-13 standard for lithium-ion batteries mandates the use of a Battery Management System (BMS). The BMS is critical for safety, as it protects the cells from over-voltage, under-voltage, high/low temperatures, and short circuits, preventing thermal runaway. Locating batteries in the engine compartment is often discouraged due to high ambient temperatures, and specific venting requirements depend on the battery chemistry and manufacturer, but a BMS is universally required.

Question 5

While inspecting the AC shore power system on a yacht, the surveyor notes that an electrical device is installed in the engine compartment where gasoline vapors could potentially accumulate. What specific characteristic must this device have to be considered safe for this location?

Accepted Answer

It must be 'Ignition Protected'.

Answer

Electrical devices located in spaces where flammable vapors (like gasoline) may be present, such as engine compartments, must be 'Ignition Protected'. This means the device is constructed to prevent it from igniting surrounding flammable gases, typically by ensuring it doesn't spark or reach a high surface temperature. This is a key safety requirement under both ABYC and U.S. Coast Guard regulations.

(SAMS) Society of Accredited Marine Surveyors Certified Practice Test

(SAMS) Society of Accredited Marine Surveyors Certified Practice Test

SAMS - Society of Accredited Marine Surveyors Certified Vessel Electrical Systems Questions and Answers