Plant Operator Selection System Algebra and Formula Conversion Questions and Answers

Question 1

The formula for electrical power is P = V * I, where P is power in watts, V is voltage in volts, and I is current in amperes. An operator needs to find the maximum current (I) a circuit can handle. Which of the following formulas is the correct rearrangement to solve for I?

Accepted Answer

I = P / V

Answer

To isolate the variable 'I' in the equation P = V * I, you need to divide both sides of the equation by 'V'. This results in P / V = (V * I) / V, which simplifies to I = P / V.

Question 2

A chemical process requires a reactor to be maintained at 150°C. The operator's local temperature gauge only displays in degrees Fahrenheit (°F). What is the equivalent temperature in °F? The conversion formula is F = (9/5)C + 32.

Accepted Answer

302°F

Answer

By substituting 150 for C in the formula F = (9/5)C + 32, the calculation is F = (1.8 * 150) + 32. This equals 270 + 32, which results in 302°F.

Question 3

A holding tank is being filled. Pump A can fill the tank at a rate of 'R' gallons per minute. Pump B fills at a rate that is 50 GPM less than twice the rate of Pump A. If both pumps are running and their combined flow rate is 400 GPM, what is the flow rate of Pump A?

Accepted Answer

150 GPM

Answer

Let 'R' be the rate of Pump A. The rate of Pump B is then 2R - 50. Their combined rate is R + (2R - 50) = 400. Simplifying the equation gives 3R - 50 = 400. Adding 50 to both sides gives 3R = 450. Dividing by 3 gives R = 150 GPM.

Question 4

An operator needs to calculate the volume of water in a 40-foot long section of pipe that has an internal diameter of 2 feet. Assuming the pipe is completely full, what is the approximate volume of water? (Use π ≈ 3.14) The formula for the volume of a cylinder is V = πr²h.

Accepted Answer

125.6 cubic feet

Answer

The formula for the volume of a cylinder is V = πr²h. The radius (r) is half the diameter, so r = 1 foot. The height (h) or length is 40 feet. Plugging these values into the formula: V = 3.14 * (1)² * 40 = 125.6 cubic feet.

Question 5

An operator is verifying a pressure calculation given by the formula: P_total = P_1 + (2/3)P_2. If the total pressure (P_total) is 80 psi and P_1 is 20 psi, what is the value of P_2?

Accepted Answer

90 psi

Answer

First, substitute the known values into the equation: 80 = 20 + (2/3)P_2. Next, isolate the term with P_2 by subtracting 20 from both sides, which gives 60 = (2/3)P_2. To solve for P_2, multiply both sides by the reciprocal of 2/3, which is 3/2. (60 * 3/2) = 90. Therefore, P_2 = 90 psi.

Plant Operator Selection System Test Practice Test

Plant Operator Selection System Test Practice Test

Plant Operator Selection System Algebra and Formula Conversion Questions and Answers