PC - Professional Electrical Contractor Grounding and Bonding Questions and Answers

Question 1

An electrical service is supplied by 3/0 AWG copper ungrounded conductors. The grounding electrode system consists solely of two 8-foot ground rods spaced 10 feet apart. According to NEC Article 250, what is the minimum size copper grounding electrode conductor (GEC) required for this installation?

Accepted Answer

6 AWG

Answer

According to NEC 250.66(A), if a grounding electrode conductor is connected only to rod, pipe, or plate electrodes, the conductor is not required to be larger than 6 AWG copper. Even though Table 250.66 would otherwise require a 4 AWG copper conductor based on the 3/0 AWG service conductors, the specific rule for ground rods limits the required size.

Question 2

A 400A feeder circuit's ungrounded conductors are increased in size from 500 kcmil copper to 750 kcmil copper to account for voltage drop. Per NEC Table 250.122, the minimum size copper equipment grounding conductor (EGC) for a 400A circuit is 3 AWG. What is the minimum size copper EGC required for this modified circuit?

Accepted Answer

1/0 AWG

Answer

According to NEC 250.122(B), when ungrounded conductors are increased in size from the minimum size that has sufficient ampacity for the intended installation, the equipment grounding conductor must be increased in size proportionately. The circular mil area of 500 kcmil is 500,000 and 750 kcmil is 750,000, a 1.5 ratio. The circular mil area of a 3 AWG conductor (52,620) must be multiplied by 1.5, resulting in 78,930 circular mils. The next standard size conductor with at least this circular mil area is 1/0 AWG.

Question 3

Which of the following best describes the primary purpose of bonding in an electrical system?

Accepted Answer

To provide a low-impedance path for fault current to facilitate the operation of overcurrent devices.

Answer

The primary purpose of bonding is to ensure electrical continuity and create a low-impedance, effective ground-fault current path. This path allows a large enough current to flow during a ground fault to quickly trip the circuit breaker or blow the fuse, clearing the fault. Grounding to earth stabilizes voltage, but bonding ensures the fault-clearing mechanism works correctly.

Question 4

A contractor installs a single ground rod as the grounding electrode for a new 200A service. A resistance measurement to earth shows a value of 30 ohms. According to the NEC, what is the appropriate next step?

Accepted Answer

Install a second grounding electrode and bond it to the first.

Answer

Per NEC 250.53(A)(2), if a single rod, pipe, or plate electrode has a resistance to earth of 25 ohms or greater, it must be supplemented by an additional electrode of a type specified in 250.52. The supplemental electrode must be installed no closer than 6 feet from the first. When a supplemental electrode is installed, the 25-ohm requirement is waived.

Question 5

In a commercial building, a metal underground water pipe is used as the primary grounding electrode. Which of the following statements is correct regarding this installation?

Accepted Answer

A supplemental grounding electrode is required.

Answer

According to NEC 250.53(D)(2), a metal underground water pipe electrode must be supplemented by an additional electrode. This is because the metal water pipe is subject to damage or replacement (e.g., with plastic pipe), which would result in the loss of the grounding electrode for the system.

(PC) Professional Electrical Contractor Practice Test

(PC) Professional Electrical Contractor Practice Test

PC - Professional Electrical Contractor Grounding and Bonding Questions and Answers