NAPA - National Automotive Parts Association Certified Mechanic Manual Drivetrain and Axles Questions and Answers

Question 1

A customer with a manual transmission vehicle complains of a high-pitched squealing noise that occurs only when the clutch pedal is fully depressed. The noise disappears as soon as the pedal is released. What is the MOST likely cause?

Accepted Answer

Worn throwout (release) bearing

Answer

The throwout bearing, also known as the release bearing, is the component that applies force to the pressure plate fingers to disengage the clutch. It is only under load and spinning when the clutch pedal is depressed. A worn or failing throwout bearing will typically make a squealing or whirring noise under this load, which goes away when the pedal is released.

Question 2

A technician is test-driving a vehicle with a manual transmission and observes that it grinds when shifting into third gear, but all other gears engage smoothly. The clutch is confirmed to be disengaging properly. What is the MOST likely cause of this issue?

Accepted Answer

A worn-out third gear synchronizer assembly

Answer

The function of a synchronizer is to match the rotational speed of the selected gear to the speed of the output shaft before the engagement sleeve locks them together. When the friction material on a specific gear's synchronizer ring is worn, it cannot effectively equalize the speeds, causing the teeth on the engagement sleeve to clash with the gear teeth, resulting in a grinding noise. Since the problem is isolated to one gear, it points to a component specific to that gear.

Question 3

A front-wheel-drive vehicle produces a rhythmic clicking or popping noise that is most prominent during sharp, low-speed turns. The noise is not present when driving in a straight line. This symptom is most indicative of a failing:

Accepted Answer

Outer Constant Velocity (CV) joint

Answer

The outer Constant Velocity (CV) joint is designed to transmit torque from the transaxle to the wheel while allowing for the wide articulation needed for steering. When the joint wears, the internal balls and cage develop excessive play. During a turn, the angle of the joint increases, and this excessive play causes the internal components to make a distinct clicking or popping sound under load.

Question 4

Which of the following symptoms is MOST commonly associated with a worn universal joint (U-joint) on a rear-wheel-drive vehicle's driveshaft?

Accepted Answer

A clunking sound when shifting from Drive to Reverse

Answer

A worn U-joint has excessive clearance in its needle bearings and cross assembly. When the direction of the driveshaft's rotation is suddenly reversed, such as when shifting from Drive to Reverse or vice-versa, this internal slack is taken up abruptly. This action produces a distinct 'clunk' or 'ping' as the driveshaft engages the differential. This can also cause a vibration at highway speeds.

Question 5

A manual transmission is difficult to shift into any gear when the vehicle is stationary and the engine is running. However, it shifts normally through all gears when the engine is turned off. Which of the following is the MOST likely cause?

Accepted Answer

A dragging clutch

Answer

A dragging clutch is one that does not fully disengage the engine from the transmission's input shaft when the pedal is depressed. With the input shaft still being spun by the engine, the synchronizers are unable to match the speeds of the gears, making it difficult or impossible to shift. When the engine is off, the input shaft is stationary, allowing for easy gear engagement without the need for synchronizers.

NAPA - National Automotive Parts Association Certified Mechanic Practice Test

NAPA - National Automotive Parts Association Certified Mechanic Practice Test

NAPA - National Automotive Parts Association Certified Mechanic Manual Drivetrain and Axles Questions and Answers