InterNACHI - International Association of Certified Home Inspectors HVAC Systems Analysis Questions and Answers

Question 1

While inspecting a central air conditioning system on a warm day, an inspector observes a significant amount of ice on the evaporator coil and the suction line. Which of the following is the most likely cause of this condition?

Accepted Answer

Restricted airflow across the evaporator coil or a low refrigerant charge.

Answer

Ice formation on the evaporator coil and suction line during cooling mode is a classic symptom of the coil becoming too cold (dropping below 32°F). This is typically caused by either insufficient warm air moving across the coil to be absorbed or a low refrigerant level, which causes a pressure drop and excessive cooling. A dirty filter is a common cause of restricted airflow.

Question 2

What does the Annual Fuel Utilization Efficiency (AFUE) rating of a furnace represent?

Accepted Answer

The percentage of fuel consumed that is converted into usable heat for the home over a year.

Answer

AFUE stands for Annual Fuel Utilization Efficiency and is a standardized measure of how efficiently a furnace converts its fuel source (like gas or oil) into heat over an entire heating season. An AFUE of 95% means that 95 cents of every dollar spent on fuel is converted to heat, while the other 5 cents are lost, typically through the flue.

Question 3

Which of the following represents the MOST significant life-safety hazard associated with a cracked heat exchanger in a gas-fired furnace?

Accepted Answer

The potential for combustion gases, like carbon monoxide, to mix with the circulated household air.

Answer

The primary and most critical danger of a cracked heat exchanger is the breach in separation between the combustion chamber and the breathable air supply. This can allow toxic flue gases, most notably carbon monoxide (CO), to enter the ductwork and be distributed throughout the home, creating a life-threatening situation.

Question 4

During an attic inspection, you observe flexible ductwork that is compressed in several areas and has multiple sharp 90-degree bends. What is the primary defect to report?

Accepted Answer

The sharp bends and compression severely restrict airflow, reducing system performance and efficiency.

Answer

Flexible ductwork must be installed with gentle bends (radius greater than one duct diameter) and without compression to ensure proper airflow. Sharp bends and kinks create significant friction and turbulence, which chokes off the airflow, leading to poor heating/cooling performance, wasted energy, and strain on the HVAC equipment.

Question 5

An inspector is examining the refrigerant lines connected to an outdoor condenser unit. One line is larger in diameter, insulated, and feels cool to the touch while the system is operating in cooling mode. This line is known as the:

Accepted Answer

Suction line

Answer

The larger, insulated copper line is the suction line (or vapor line). It carries cool, low-pressure refrigerant in a gaseous state from the indoor evaporator coil back to the outdoor compressor. It is insulated to prevent it from absorbing excess heat from the ambient air, which would decrease the system's efficiency.

(InterNACHI) International Association of Certified Home Inspectors Practice Test

(InterNACHI) International Association of Certified Home Inspectors Practice Test

InterNACHI - International Association of Certified Home Inspectors HVAC Systems Analysis Questions and Answers