GD&T - Geometric Dimensioning and Tolerancing Datum Reference Frames Questions and Answers

Question 1

In a standard Datum Reference Frame (DRF), what is the minimum number of points of contact required for the primary datum feature to constrain the part?

Accepted Answer

Three points

Answer

According to the 3-2-1 rule in GD&T, the primary datum feature requires a minimum of three points of contact to properly establish a plane. This constrains three degrees of freedom: one translational (e.g., Y-axis) and two rotational (e.g., u and w rotations).

Question 2

A drafter specifies two separate, coplanar surfaces on a part as a single primary datum feature. Which of the following geometric tolerances is best suited to control the relationship between these two surfaces?

Accepted Answer

Profile of a Surface

Answer

Profile of a Surface is the most appropriate control for two coplanar surfaces designated as a single datum. It establishes a tolerance zone of two parallel planes within which both surfaces must lie, thereby controlling their form and coplanarity relative to each other.

Question 3

Which of the following best describes the relationship between a 'datum feature' and a 'datum'?

Accepted Answer

A datum feature is a tangible surface on the part, while a datum is the theoretically exact point, axis, or plane derived from it.

Answer

A datum feature is a real, physical feature on the component (like a surface or a hole). A datum is the theoretically perfect point, line, axis, or plane that is derived from the datum feature and simulated by inspection equipment (like a granite surface plate or a gage pin).

Question 4

An engineering drawing shows a feature control frame referencing datums in the order |A|B|C|. What does this order of precedence signify during inspection?

Accepted Answer

The part must first be constrained by the simulator for datum A, then B, and finally C.

Answer

The order of datums in a feature control frame dictates the sequence of constraining the part's degrees of freedom. The primary datum (A) is engaged first, followed by the secondary (B), and then the tertiary (C). This sequence is critical for a repeatable and correct inspection setup.

Question 5

In a scenario where a cylindrical hole is designated as a primary datum feature, what does the resulting datum represent?

Accepted Answer

The theoretically exact axis of the datum feature simulator that contacts the high points of the hole.

Answer

When a feature of size like a cylindrical hole is a datum feature, the datum itself is not the surface but its theoretically exact axis. This axis is derived from the datum feature simulator (e.g., an expanding gage pin) which makes contact with the high points of the actual, imperfect hole surface.

(GD&T) Geometric Dimensioning and Tolerancing Certification Practice Test

(GD&T) Geometric Dimensioning and Tolerancing Certification Practice Test

GD&T - Geometric Dimensioning and Tolerancing Datum Reference Frames Questions and Answers