Gas Safe ACS - Accredited Certification Scheme Chimney and Flue Systems Questions and Answers

Question 1

An engineer is installing a new, room-sealed, fanned-draught boiler. According to BS 5440-1, what is the minimum horizontal distance required between the centre of the flue terminal and an opening window on the same wall?

Accepted Answer

300 mm

Answer

BS 5440-1 specifies the minimum clearances for flue terminals to prevent products of combustion from re-entering the property. For a fanned-draught, room-sealed appliance, the minimum horizontal distance from the centre of the terminal to an opening (such as a window or door) is 300 mm.

Question 2

When performing a spillage test on a conventional open-flued appliance, after allowing it to operate for an initial period, what is the minimum duration the smoke test should be observed at the draught diverter opening?

Accepted Answer

2 minutes

Answer

The standard procedure for a spillage test requires the engineer to observe the smoke from a smoke match or pellet at the edge of the draught diverter. After an initial warm-up period, if spillage occurs, the appliance is left to run for a further 10 minutes and then re-tested. The smoke test itself must be observed for a period of 2 minutes to ensure all products of combustion are being safely removed by the flue.

Question 3

An engineer is assessing a masonry chimney for use with a new inset live fuel effect gas fire. Which of the following is a primary requirement before the appliance can be installed?

Accepted Answer

The chimney must be swept, and its integrity and suitability confirmed, being lined if necessary.

Answer

Before using an existing masonry chimney for a gas appliance, its safety and suitability must be established. This involves having the chimney thoroughly swept to remove soot and blockages, followed by an integrity test (e.g., a smoke test) to ensure there are no leaks. If the chimney fails the test or is otherwise unsuitable (e.g., too large), it must be relined with a suitable flue liner specified for gas appliances.

Question 4

While servicing a condensing boiler, an engineer finds that the plastic flue pipe runs through an unheated loft space but has not been insulated. What is the primary safety concern associated with this installation fault?

Accepted Answer

Condensate within the flue could freeze, leading to a blockage and appliance shutdown or malfunction.

Answer

Condensing boilers produce acidic condensate as a by-product of combustion. This liquid flows back down the flue system to a drain. In unheated areas like a loft or garage, this condensate can freeze during cold weather, creating an ice blockage in the flue. This blockage will activate the boiler's safety sensors and cause it to shut down, or in a worse-case scenario, lead to the unsafe operation of the appliance. Manufacturer's instructions and industry standards require the flue to be insulated in such spaces to prevent this.

Question 5

An engineer is called to a property where the homeowner reports fumes from an open-flued gas fire. The engineer finds the flue is completely blocked by a bird's nest. How should this situation be classified according to the Gas Industry Unsafe Situations Procedure (GIUSP)?

Accepted Answer

Immediately Dangerous (ID)

Answer

An 'Immediately Dangerous' (ID) situation is one that poses an immediate danger to life or property. A completely blocked flue on an open-flued appliance will cause the products of combustion, including poisonous carbon monoxide, to spill directly into the room. This presents a severe and immediate risk to the occupants, and therefore must be classified as ID. The engineer must immediately turn off the appliance, isolate the gas supply to it, and issue a warning notice.

Gas Safe ACS Practice Test

Gas Safe ACS Practice Test

Gas Safe ACS - Accredited Certification Scheme Chimney and Flue Systems Questions and Answers