FREE Ham Radio General Class Test Radio Wave Propagation Questions and Answers

Question 1

During the day, which ionospheric layer is most responsible for absorbing HF signals, particularly on the lower frequency bands like 40 and 80 meters?

Accepted Answer

The D layer

Answer

The D layer of the ionosphere forms during daylight hours and is the lowest of the ionospheric layers. It primarily absorbs or attenuates HF radio waves, rather than refracting them. This absorption effect is most pronounced on lower HF frequencies, such as the 80 and 40-meter bands, which is why these bands are typically better for long-distance communication at night when the D layer disappears.

Question 2

A ham operator in Florida is trying to contact another operator in California on the 20-meter band. They can hear stations from Europe but not the station in California. What is the most likely reason for this?

Accepted Answer

The California station is in the operator's skip zone.

Answer

The skip zone is an area between the end of the ground wave coverage and the point where the first skywave returns to Earth. It's a 'dead zone' where the signal cannot be received. It is entirely possible for a signal to skip over a closer station (like the one in California) and be received at a much greater distance (like Europe) due to the angle of refraction from the ionosphere.

Question 3

Which of the following propagation modes is most likely responsible for enabling long-distance communication on VHF and UHF bands, often extending several hundred miles?

Accepted Answer

Tropospheric ducting

Answer

Tropospheric ducting occurs when a temperature inversion creates a 'duct' in the troposphere (the lowest layer of the atmosphere). This duct can trap and guide VHF and UHF radio waves, allowing them to travel far beyond the normal line-of-sight distance, often for hundreds or even over a thousand kilometers.

Question 4

What is the relationship between operating frequency and the Maximum Usable Frequency (MUF) for the best long-distance HF communication?

Accepted Answer

Operating at a frequency just below the MUF is generally best.

Answer

The Maximum Usable Frequency (MUF) is the highest frequency that will be refracted back to Earth for a given path. Frequencies significantly above the MUF will pass through the ionosphere into space. For the strongest signal with the least absorption, the optimal operating frequency is typically just below the MUF.

Question 5

Why are the higher HF bands, such as 15, 12, and 10 meters, generally more effective for long-distance communication during the daytime?

Accepted Answer

The F2 layer is more ionized by the sun during the day, allowing it to refract higher frequencies.

Answer

During the day, solar radiation intensely ionizes the F2 layer, making it dense enough to refract higher frequencies back to Earth. The D-layer, also present during the day, absorbs lower frequencies. Therefore, the higher HF bands perform better for long-distance skywave propagation during daylight hours.

Ham Radio General Class Test Practice Test

Ham Radio General Class Test Practice Test

FREE Ham Radio General Class Test Radio Wave Propagation Questions and Answers