FREE E2 Working Space and Clearances Questions and Answers

Question 1

What is the minimum depth of working space required in front of a 480V switchboard with exposed live parts on one side and grounded parts on the other side?

Accepted Answer

3 feet 6 inches

Answer

According to NEC Table 110.26(A)(1), for systems with a nominal voltage to ground of 151-1000V, Condition 2 (Exposed live parts on one side and grounded parts on the other side) requires a minimum clear distance of 3 feet 6 inches.

Question 2

The minimum required width of the working space in front of a 24-inch wide panelboard must be:

Accepted Answer

30 inches

Answer

NEC 110.26(A)(2) states the width of the working space shall be the width of the equipment or 30 inches, whichever is greater. Since the panelboard is 24 inches wide, the minimum required working space width is 30 inches.

Question 3

What is the minimum headroom of working space required for service equipment located in a commercial building?

Accepted Answer

6 feet 6 inches or the height of the equipment, whichever is greater

Answer

As per NEC 110.26(E), the minimum headroom of working spaces about service equipment, switchboards, and panelboards shall be 6 feet 6 inches or the height of the equipment, whichever is greater. This ensures adequate vertical space for personnel.

Question 4

A large switchboard is rated 1200 amperes and is over 6 feet wide. What is required for personnel entrance and egress?

Accepted Answer

One entrance at each end of the working space

Answer

NEC 110.26(C)(2) requires one entrance to and egress from the required working space not less than 24 inches wide and 6 feet 6 inches high at each end of the working space for equipment rated 1200 A or more and over 6 ft wide. This provides two paths of exit in case of an emergency.

Question 5

Equipment doors that open into the required working space must be able to open to an angle of at least:

Accepted Answer

90 degrees

Answer

NEC 110.26(A)(3) requires that where equipment doors are installed, they must be able to open to at least a 90-degree position. This ensures that the doors do not obstruct the required working space when service is being performed.

(E2) E2 Commercial Electrical Inspector Practice Test

(E2) E2 Commercial Electrical Inspector Practice Test

FREE E2 Working Space and Clearances Questions and Answers