FREE E2 General Requirements and NEC Questions and Answers

Question 1

According to NEC Article 110, what is the minimum required width of the working space in front of a commercial switchboard that is 48 inches wide?

Accepted Answer

The width of the equipment or 30 inches, whichever is greater

Answer

NEC 110.26(A)(2) states that the width of the working space in front of electrical equipment shall be the width of the equipment or 30 inches, whichever is greater. This ensures adequate room for a worker to safely perform tasks. In this case, since the switchboard is 48 inches wide, the working space must be at least 48 inches wide.

Question 2

An electrical inspector is examining a new installation in a commercial building. Which of the following defines the term 'Approved' as used in the NEC?

Accepted Answer

Acceptable to the authority having jurisdiction (AHJ)

Answer

NEC Article 100 defines 'Approved' as 'acceptable to the authority having jurisdiction.' While listing and compliance with other codes are important considerations for the AHJ, the final approval rests with them.

Question 3

A commercial service equipment rated 1200A or more is being installed. Which of the following markings is specifically required by NEC 110.24 to be field-applied to this equipment?

Accepted Answer

The maximum available fault current and the date of calculation

Answer

NEC 110.24(A) requires service equipment in other than dwelling units to be legibly marked in the field with the maximum available fault current. The marking must also include the date the fault-current calculation was performed. This information is crucial for ensuring the equipment's short-circuit current rating is adequate.

Question 4

During an inspection of a commercial office space, you find a service disconnecting means installed inside the building. According to NEC 230.70(A)(1), the disconnect must be located:

Accepted Answer

At a readily accessible location nearest the point of entrance of the service conductors

Answer

NEC 230.70(A)(1) mandates that the service disconnecting means shall be installed at a readily accessible location, either outside of a building or structure or inside nearest the point of entrance of the service conductors. This minimizes the length of unprotected service conductors within the building.

Question 5

Which of the following must be evaluated when judging the suitability of electrical equipment for a commercial installation, according to NEC 110.3(A)?

Accepted Answer

Mechanical strength and durability

Answer

NEC 110.3(A) provides a list of considerations for evaluating equipment. These include mechanical strength, wire-bending space, electrical insulation, heating effects, arcing effects, and other factors related to the practical safeguarding of persons.

(E2) E2 Commercial Electrical Inspector Practice Test

(E2) E2 Commercial Electrical Inspector Practice Test

FREE E2 General Requirements and NEC Questions and Answers